Cooper Lighting H17250QT4, H17500QT4 User Manual

CAUTION: To avoid possible electrical shock, be sure that power supply is

turned off before installing or servicing this fixture.

STEP 1:

STEM/CANOPY MOUNT (Figure 1)

• Secure canopy assembly to the outlet box with screws (included
in the Pendant Kit).

• Attach stem to the canopy and to housing.

• Make wiring connections.

SURFACE MOUNT

• The cylindrical housing is attached to the outlet box (on ceiling)
by using (2) mounting screws shown in Figure 2.

• Make wiring connections.

STEP 2: To Install Upper Reflector: Cut plastic tie wrap securing heat sink to

bracket. Install quartz mini-can frosted lamp. Make sure the lamp
wattage matches the markings on the heat sink.

WARNING: DO NOT handle quartz lamps with bare hands.
Grease from fingerprints may cause premature end of life or
shattering of lamp.

Install heat sink to upper reflector assembly carefully guiding lamp
into reflector opening (Figure 3). Rotate heat sink until flanges are
seated under retention springs(Figure 4). Insert this completed
assembly into the cylindrical housing until seated securely.

PORTFOLIO

Installation Instructions for H17500QT4 and H17250QT4 Commercial Surface
Cylinders and for H77500QT4 and H77250QT4 Wall Mount Cylinders

Customer First Center 1121 Highway 74 South Peachtree City, GA 30269 12/18/06 704244

Figure 3

Figure 1 Figure 2

Pendant Kit, H836
(Sold Separately)

Housing

Heat Sink and
Lamp Assembly

Upper Reflector

Assembly

Lower Reflector
Assembly

Mounting Screws

Heat Sink

Lamp

Upper Reflector
Assembly

Reflector
Opening

PORTFOLIO

TO INSTALL LOWER REFLECTOR ASSEMBLY

STEP 3: Attach safety tether from lower reflector assembly to mounting bracket inside the can via clip.
Reflector Assembly is held in place with torsion springs that pass through slots inside the can. (Figure 5)

WALL MOUNT ONLY

STEP 4: Install wall housing/wall bracket shown in Figure 6 over the outlet box on the wall.

STEP 5: Using the (2) screws shown in Figure 5, secure the assembly to the outlet box.

STEP 6: Make wiring connections.

STEP 7: Follow steps 2-3 for trim installation.

RELAMPING: Allow sufficient time for the lamp to cool. Relamping can be performed from below the

fixture.

To relamp from below the fixture: Remove lower trim and then remove
upper reflector by pressing the four retention springs inward (Figure 7).
Rotate heat sink to clear retention springs and carefully separate from
reflector assembly. Replace lamp and reassemble as described in steps
1-4.

CLEANING: First, gently wipe with a soft, clean, dry lint-free cloth to
remove loose dust. Then, use mild detergent solution on a soft cloth to
remove finger prints and stains. Rinse with clean, soft water and dry with
lint-free cloth.

Customer First Center 1121 Highway 74 South Peachtree City, GA 30269 12/18/06 704244

WALL MOUNT ONLY

Figure 4

Figure 7

Figure 6

Figure 5

For Clarity, Housing
Can is not shown

Hole that
safety tether
clips

Clip

Safety
Tether

Slots that Torsion
Spring Hooks into

Torsion
Springs

Screws

Wall Bracket

Screws

Depress these 4 retention springs
to install/remove the upper trim.