Cooper Lighting MX1, CMX1, MX1W, CMX1W Instruciton Manual
ENGLISH
ESPAÑOL
FRANÇAIS
MX1, CMX1
MX1W, CMX1W
Instruction Manual
Instucciones
Directives
MX1_W 825-0148.qxd:MX1 MX1W 325-1523.qxd 5/13/08 10:25 AM Page 1
MX1, CMX1 (Bronze)
MX1W, CMX1W (White)
ENGLISH
2
Call for customer service and/or missing or damaged parts (800-334-6871)
Congratulations! You have purchased a Cooper Lighting, LLC twin quartz
halogen floodlight. This security lighting system is a decorative way to provide
years of trouble-free convenience and protection for your home and family. This
floodlight is perfect for illuminating walkway entrances, signs, driveways, yards,
patios, and recreational areas.
What you need
• Screwdriver
• Silicone caulking
What’s included
• Light fixture (A)
• (2) 100 watt quartz halogen bulbs (B)
• (3) Wire nuts (C)
• Coverplate gasket (D)
• (2) #8 Screws (E)
• (2) #6 Screws (F)
• Mounting bracket with ground wire (G)
• Center bolt (H)
What to know
• For outdoor use only.
• cULus Listed for wet locations use.
• Fixture must be connected to a 120 volt, 60 Hz power source (any other
connection voids warranty).
• This Cooper Lighting, LLC twin quartz halogen floodlight should be installed
by a qualified electrician or by persons with experience in household wiring.
The electrical system, and the method of electrically connecting this fixture to
it, must be in accordance with the National Electrical Code and local
building codes.
• Fixture should be mounted to a grounded junction box marked for use
in wet locations. Junction box must be at least 1-1/2˝ in depth for proper
installation.
• Keep away from flammable objects. Do not mount body of
fixture within one inch of any combustible material.
• The bulb and fixture get extremely hot during use.
• Always replace bulb with the same wattage or lower wattage than included.
Installing a bulb of a higher wattage could create a fire hazard. Use of higher
wattage bulb will void the warranty.
• Never touch the bulb with your bare hands, as oil from your skin can cause
premature failure. Always handle the bulb with gloves or a soft cloth.
B
A
C
D
E
F
G
H
MX1_W 825-0148.qxd:MX1 MX1W 325-1523.qxd 5/13/08 10:25 AM Page 2
ENGLISH
3
Call for customer service and/or missing or damaged parts (800-334-6871)
• Disassembly of your fixture will void the warranty.
• Your light fixture is prewired for easy installation.
• For supply connections, use wire rated at least 90 degrees C.
• In the event of glass breakage, the entire lens cover must be replaced
per UL requirements. Contact Customer Service for ordering assistance
(1-800-334-6871).
Installing the bulb
Step 1: Remove the lens cover by twisting it one-half turn counter-clockwise.
Step 2: Using gloves or a soft cloth, gently plug bulb into housing.
Note: Align two pins located at the end of the bulb with two small holes in the
center of housing, and press until firmly seated. Repeat this procedure for the
other light.
Step 3: Replace the lens (making sure the gasket is in place) by aligning
the notches on the housing with the cover and pressing until seated.
Twist one-half turn clockwise until tight.
Note: Replace only with a 120 Volt, 100 watt (or lower wattage) GY8.6 base
bi-pin capsule halogen bulb (Cooper Lighting, LLC model MX100BP replacement bulbs).
Installing your fixture
WARNING: Risk of electric shock.
Note: Estimated assembly/installation time is 15 minutes.
Step 1: Turn off the power at the main fuse/breaker box. Check to make
sure power has been disconnected before continuing.
Step 2: Line up the holes on the mounting bracket with the holes on your
junction box. Using either (2) #6 screws or (2) #8 screws
(depending on the size of your junction box holes). Attach the
mounting bracket to your junction box. Junction box must be at least
1-1/2˝ in depth for proper installation.
Step 3: Thread fixture wires through coverplate gasket.
Step 4: Connect black wires from both lights to house black wire, white wires
from both lights to house white wire, and copper ground wire from
mounting bracket to house ground wire using wire nuts provided.
Step 5: Attach fixture to the mounting bracket using the center bolt provided.
Step 6: Apply silicone caulking around the edges of coverplate to provide
a watertight seal from rain and moisture.
Step 7: Turn on power at main fuse/breaker box.
Note: This fixture can be used with a dimmer switch to adjust light
output. To install a dimmer switch: Use a dimmer switch designed for
incandescent lighting that has a rating of 200 watts or higher. Follow the
installation instructions included with the dimmer switch. Keeping the halogen
bulb in a dim mode for an extended period of time may shorten the life of
the bulb. To achieve maximum bulb life, occasionally turn the switch to
full brightness for a few hours.
MX1_W 825-0148.qxd:MX1 MX1W 325-1523.qxd 5/13/08 10:25 AM Page 3
ENGLISH
What to do if...
Two-year limited warranty
Cooper Lighting, LLC (“the Company”) warrants this product (“the product”)
against defects in material or workmanship for a period of two years from date
of original purchase, and agrees to repair or, at the Company!s option, replace a
defective product without charge for either replacement parts or labor during
such time. This does not include labor to remove or install fixtures.
This warranty is extended only to the original purchaser of the product.
A purchasers receipt or other proof of date of original purchase acceptable to
the Company is required before warranty performance shall be rendered.
This warranty only covers product failure due to defects in materials or
workmanship which occurs in normal use. It does not cover the bulb or failure
of the product caused by accident, misuse, abuse, lack of reasonable care,
alteration, or faulty installation, subjecting the product to any but the specified
electrical service or any other failure not resulting from defects in materials or
workmanship. Damage to the product caused by separately purchased,
non-Company brand replacement bulbs and corrosion or discoloration of brass
components are not covered by this warranty.
There are no express warranties except as described above.
THE COMPANY SHALL NOT BE LIABLE FOR INCIDENTAL, SPECIAL OR
CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THE
PRODUCT OR ARISING OUT OF ANY BREACH OF THIS WARRANTY. ALL
IMPLIED WARRANTIES, IF ANY, INCLUDING IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE
LIMITED IN DURATION TO THE DURATION OF THIS EXPRESS WARRANTY.
Some states do not allow the exclusion or limitation of incidental or
consequential damages, or limitations on how long an implied warranty lasts, so
the above exclusions or limitations may not apply to you.
No other warranty, written or verbal, is authorized by the Company.
This warranty gives you specific legal rights, and you may also have other rights
which vary from state to state.
To obtain warranty service, please write to: Cooper Lighting, LLC, 1121 Highway
74 South, Peachtree City, GA 30269. Enclose product model number and
problems you are experiencing, along with your address and telephone number. You will then be contacted with a solution, or a Return Goods
Authorization number and full instructions for returning the product. All
returned products must be accompanied by a Return Goods Authorization
Number issued by the Company and must be returned freight prepaid.
4
Lights do not come on
Is there power to the fixture?
• Has the house circuit breaker tripped?
• Is the wall switch on?
Are the bulbs firmly seated? Are the bulbs good? (Be careful
not to break pins on bulb when seating.)
Is the wire to the unit loose?
TURN OFF POWER BEFORE CHECKING
Call for customer service and/or missing or damaged parts (800-334-6871)
MX1_W 825-0148.qxd:MX1 MX1W 325-1523.qxd 5/13/08 10:25 AM Page 4
ENGLISH
5
Any product received without a Return Goods Authorization Number from
the Company will be refused.
Cooper Lighting, LLC is not responsible for merchandise damaged in transit.
Repaired or replaced products shall be subject to the terms of this warranty and
are inspected when packed. Evident or concealed damage that is made in
transit should be reported at once to the carrier making the delivery and a claim
filed with them.
Customer First Center
1121 Highway 74 South, Peachtree City, GA 30269
www.cooperlighting.com
Patent D374,496
© 2008 Cooper Lighting, LLC
Reproductions of this document without prior written approval of Cooper Lighting, LLC
are strictly prohibited.
Call for customer service and/or missing or damaged parts (800-334-6871)
Printed in China
MX1_W 825-0148.qxd:MX1 MX1W 325-1523.qxd 5/13/08 10:25 AM Page 5
Loading...