Cooper Lighting AMETRIX Fixture Doors User Manual

Supplementary Installation Instructions

Sheet 1 of 1

Removing and Sealing Ametrix Fixture Doors

Specific details such as fixture and pendant style may differ,
however the mounting configurations are universal.

To Remove Fixture Door

Screws on outdoor

Door Latch

15

If fixture is indoor, slide door latches to open.

1.

2. If fixture is outdoor, remove screws and slide door latches to

open.

#6-32 x5/8" (15.8mm)
Socket cap allen screw

2

fixture only

Torque Sequence

2 & 3ft Fixtures

This side
to surface

Warning

that all sources of power are turned off. All
work must meet local/national codes and be
performed by a certified electrician.
mount fixtures vertically.

3. After releasing door, hold door at approximately a
fifteen degree angle and push door away from fixture.

: Before starting any work ensure

Do not

3

4

#6-32 x1/2" (12.7mm)
Socket cap allen screw

#6-32 x5/8" (15.8mm)
Socket cap allen screw

2

4

#6-32 x1/2" (12.7mm)

1. Tighten each screw in the order specified above.

2. Using torque Allen driver, and beginning with screw 1, tighten screw to 5 inch pounds of torque.

3. Next, tighten screw 2 to 5 inch pounds of torque.

4. Continue through all screws, following above sequence, tightening each screw to 5 inch pounds of torque.
Repeat sequence tightening all screws to a final 10 inch pounds of torque.

5.

5 1

#6-32 x1/2" (12.7mm)
Socket cap allen screw

1

#6-32 x1/2" (12.7mm)
Socket cap allen screw

4ft Fixtures

5

#6-32 x1/2" (12.7mm)
Socket cap allen screw

#6-32 x5/8" (15.8mm)

3

Socket cap allen screw

#6-32 x1/2" (12.7mm)
Socket cap allen screwSocket cap allen screw

#6-32 x1/2" (12.7mm)

6

Socket cap allen screw

#6-32 x5/8" (15.8mm)
Socket cap allen screw

ADY071485 REV A(ECN070344)