Cooper Lighting Ametrix ADY071481, Ametrix Vault, Ametrix C-Scroll, Ametrix Roundel Installation Instructions Manual
Vault
These installation instructions are valid with the above Ametrix styles.
C-Scroll
Roundel
Installation Instructions
Sheet 1 of 3
Large, OUTDOOR
CR
(Cantilever, Remote ballast)
Visor and Non-Visor
Warning
that all sources of power are turned off. All
work must meet local/national codes and be
performed by a certified electrician.
mount fixtures vertically.
: Before starting any work ensure
Do not
Exploded view and part call-out
#8-32 x3/8"
Set screw
Canopy
1/4-20 x3/4"
Hex bolts
(2x)
Fixture head
(2x)
Yoke assembly
Yoke end cap
#10-32 x1
End screw
(2x)
Attention:
All large fixtures require additional bracing/structure
around J-box to support fixture.
2
1/4-20 x3/4"
Hex bolts
(2x)
Securing fixture to cantilever
#6-32 x1/4"
Flat head screw
Yoke arm
end cap
1
Use additional bracing around
J-box to support J-box.
Canopy
1. Prior to attaching fixture head to cantilever, remove both
#8-32 x3/8" set screws and allow canopy to slide down
pendant.
2. Feed power wire through wiring holes and using appropriate
fasteners, secure mounting plate to structure.
3
Mounting cantilever to structure
#8-32 x3/8"
Set screw
J-box
(by others)
Mounting plate
1/4" fastener
(by others)
(4x)
Wiring the fixture
#8-32 x 3/8"
Set screws
(2x)
Canopy
Wiring holes
Fixture head
1. To remove fixture head from yoke assembly, remove #10-32
x1" end screw from one side.
2. Remove the #6-32 x1/4" Flat head screw from the inside of the
yoke arm and remove the yoke end cap.
With fixture head removed, secure yoke to cantilever using
3.
1/4-20 x3/4" hex bolts.
Run wiring from fixture head, into pendant and out holes in
4.
mounting plate.
ADY071481 REV A(ECN080352)
#10-32 x1"
End screw
1. After pulling wires through wiring holes in mounting plate,
attach appropriate wires and ensure all connections are
properly matched.
Push connections into J-box and secure canopy using both
2.
#8-32 x3/8" set screws.
Refer to supplementary sheet for instructions on aiming and
3.
sealing the fixture.
Vault w/ visor
These installation instructions are valid with the above Ametrix styles
C-Scroll w/ visor
Mounting plate dimensions In[mm]
Roundel w/ visor
Installation Instructions
Sheet 2 of 3
Large, OUTDOOR
CR
(Cantilever, Remote ballast)
Visor and Non-Visor
Warning
that all sources of power are turned off. All
work must meet local/national codes and be
performed by a certified electrician.
mount fixtures vertically.
: Before starting any work ensure
Do not
Top View
127
5"
88.90
1
3
2
38.10
1
1
"
2
19.05
3
"
4
19.05
3
"
4
"
7.11
9
32
"
127
88.90
1
3
2
"
5"
Side View
ADY071481 REV A(ECN080352)
Length dependant
on order
12.70
1
"
2
Loading...