Cooper Lighting ADY080864 User Manual

Warning

that all sources of power are turned off. All
work must meet local/national codes and be
performed by a certified electrician.
mount fixtures vertically.

: Before starting any work ensure

Do not

J-box
(by others)

Canopy

1/4-20 x1"
Aiming screw

Installation Instructions

Sheet 1 of 3

Roundel, XL

INDOOR

PS

(Pendant Swivel)

Visor and Non-Visor

Exploded View and Part Call-Out

Pendant length dependant

Mounting bracket

on order(multiple sections
may be required, consult
factory for coupler and
safety wire installation
requirements).

End cap

#8-32 x.75"
Cap screw
(x2)

3/8-16 x1"
Hex end screw
(x2)

All extra large fixtures require additional bracing/structure around J-box to support fixture.

1.

Securing Power side Pendant to Ceiling

J-box
(by others)

Mounting plate

Appropriate fasteners
(by others)
(x2)

Attention:

2.

Appropriate fasteners
(by others)
(x2)

Fixture door

Securing non-Power side Pendant

Mounting plate

Canopy

1.

Remove canopy and allow it slide down pendant.

2.

Using appropriate fasteners(by others), secure mounting

plate to structure/ bracing around J-box.

3.

For mounting plate dimensions refer to page three(3).

ADY080864 REV B(ECN080377)

Canopy

1.

To mount non-power side pendant, use dimensions provided

on page three(3).

2.

Using appropriate fasteners(by others), secure mounting plate

to structure/ bracing in ceiling.

Warning

that all sources of power are turned off. All
work must meet local/national codes and be
performed by a certified electrician.
mount fixtures vertically.

: Before starting any work ensure

Do not

Installation Instructions

Sheet 2 of 3

Roundel, XL

INDOOR

PS

(Pendant Swivel)

Visor and Non-Visor

3. 4.

1/4-20 x1"
Aiming Screw
(x2)

Fixture wire

1.

After hanging both pendants, carefully lift fixture head into

place.

2.

Secure fixture using both 3/8 -16 x 1" End screws.

3.

Secure desired angle using 1/4-20 x 1" Aiming screws.

5.

Mounting Fixture to Pendants

Canopy

Fixture wire

3/8-16 x1"
End Screw
(x2)

1.

up pendant tube to J-box.

2.

matched.

3.

Securing Safety Wires and Aiming the Fixture

Wiring the Fixture

After securing the fixture head to the pendants, run fixture wire

Attach appropriate wires ensuring all connections are properly

Secure canopy to mounting plate.

#8-32 x.75"
End Screw
(x2)

1/4"-20 safety wire
connector
(x2)

End Cap

1.

To secure safety wire to fixture, screw 1/4"-20 wire connector to bottom of pendant bracket.

2.

Run safety wire up pendant tube and secure to structure in ceiling.

3.

To adjust angle of fixture head, loosen both 1/4-20 x1" aiming screws.

4.

Rotate fixture head to desired angle and secure with both 1/4-20 x1" aiming screws.

5.

Replace end cap using 8-32 x.75" end screw.

J-box hidden
for clarity

40

Side view

ADY080864 REV B(ECN080377)