Cooper Lighting ADY071473 User Manual
Vault
These installation instructions are valid with the above Ametrix styles.
C-Scroll
Roundel
Installation Instructions
Sheet 1 of 3
Large, OUTDOOR
P1R
(Pendant, 1-way, Remote ballast)
Visor and Non-Visor
Warning
that all sources of power are turned off. All
work must meet local/national codes and be
performed by a certified electrician.
mount fixtures vertically.
: Before starting any work ensure
Do not
Exploded view and part call-out
Mounting plate
Canopy
#10-32
End screw
(2x)
Appropriate fasteners
(by others)
(2x)
#10-32 x 3/8"
Pan head screw
(2x)
1/4-20x 3/4"
Hex cap screw
(2x)
Attention:
Large fixtures require additional bracing/structure
around J-box to support fixture.
2
J-box
(by others)
fasteners
(by others)
(4x)
Canopy
Mounting and wiring fixture
Use additional bracing
around J-box to support
fixture.Appropriate
#6-32 x 3/8"
Pan head screws
(2x)
1
Wire connector
#6-32 x 1/4"
Flat head screw
End cap
End screw
(2x)
1. Begin by removing end screw, #6-32 x 1/4" Flat head screw
and end cap from one side of Yoke and remove fixture head.
Mount yoke to pendant with both 1/4-20 Hex cap screws.
2.
3.
Feed fixture wire through connector in pendant up through
mounting plate and reattach fixture head to yoke.
3
Securing fixture to pendant
Mounting plate
Yoke
Fixture wire
1/4-20 x 3/4"
Hex cap screw
(2x)
Sealing the fixture
#6-32 x 1/2"
Socket cap screw
(2x)
1. Loosen #6-32x 3/8" Pan head screws and allow canopy to slide
down pendant.
2. Feed wires from J-box through wire ways in mounting plate
and secure fixture to bracing around J-box.
Attach appropriate wires and ensure all connections are
3.
properly matched.
Replace canopy and secure with both #6-32 x3/8" Pan head
4.
screws.
ADY071473 REV A(ECN070347)
Wire seal
#6-32 x 5/8"
Socket cap screw
1. To seal fixture, secure all socket cap screws according to
sequence and torque specifications on supplementry sheet.
2. Ensure a smooth and sealed connection at wire seal.
3. For aiming instructions refer to aiming supplementry sheet
Vault w/ visor
These installation instructions are valid with the above Ametrix styles
C-Scroll w/ visor
Mounting Plate Dimensions In[mm]
Roundel w/ visor
19.05
3
"
4
Installation Instructions
Sheet 2 of 3
Large, OUTDOOR
P1R
(Pendant, 1-way, Remote ballast)
Visor and Non-Visor
Warning
that all sources of power are turned off. All
work must meet local/national codes and be
performed by a certified electrician.
mount fixtures vertically.
: Before starting any work ensure
Do not
127
5"
88.90
1
3
2
12.70
38.10
1
1
"
2
19.05
3
"
4
"
Top View
7.11
9
88.90
1
3
2
"
32
"
127
5"
1
"
2
ADY071473 REV A(ECN070347)
Side View
Length dependant
on order
Loading...