Page 1
Anchors
Bang-It™†Anchors
• Bang-It™concrete inserts are designed for installation in and
through metal composite deck used to support newly poured
concrete floors or roof slabs.
• After installation, the protective sleeve of the insert protrudes
below the surface of the deck, allowing overhead attachment of
threaded rod.
• The unique, six sided impact plate offers resistance to rotation
within the concrete as threaded rod is
bing
installed.
• Suitable for overhead installations
such as suspending cable tray, pipe
hangers, strut and conduit.
• Color coded by size for all trades.
• UL and FM approved.
• Lowest in-place cost.
Bang-It™- Data
Metal Hole Saw Diameter (in.)13/16
1
/4"3/8"1/2"5/8"3/4"
13
/1613/16 13/16 13/16
Drilling Speed (rpm) 700-900 700-900 700-900 500-700 500-700
3
5
11
Insert Thread Length
(in.)
/8
/8
15
/16
/16 11/8
Length of Sleeve (in.) 33/8 33/8 33/8 33/8 33/8
Thread Size (UNC)
Embedment Depth
(in.) 2 22 22
Upper Deck Tension Load
Lower Deck Tension Load
Upper Deck Shear Load
Lower Deck Shear Load
* Based on sand lightweight and normal weight concrete with minimum
compression strength of 3000 psi over steel deck. Allowable load capacities are
calculated using applied safety factor of 3.0. For additional loading information
contact factory. Minimum insert spacing of 6", minimum end spacing 6".
1
/4"-203/8"-161/2"-135/8"-113/4"-10
(lbs) * 1115 1915 2370 2935 2935
(lbs) * 830 830 830 990 990
(lbs) * 83 5 1115 1115 111 5 1115
(lbs) * 625 840 840 840 840
UPC/Part Catalog Rod Color Box
Number Number Diameter Qty.
™
Bang-It
78205131154 ACPD-25
78205131156 ACPD-38
78205131157 ACPD-50
78205131158 ACPD-62
78205131166 ACPD-75
1
/4" Brown 100
3
/8" Green 100
1
/2" Yellow 100
5
/8" Red 50
3
/4" Purple 50
Bang-It™Hole Saws
78205131169 ACPD-HS81313/16" Carbide Hole Saw 1
78205131171 ACPD-HS1188
ICC-ES certified. See ICC-ES ESR-3657. Qualified for static, wind, and
seismic loading in concrete.
† Bang-It™is a registered trademark used by Power®Fasteners, Inc.
Read safety/installation instruction sheets in packages before use.
1
/4", 3/8", 1/2"
for
3
1
/16" Carbide Hole Saw 1
5
/8", 3/4"
for
Anchors
Eaton's B-Line series fasteners www.eaton.com/b-lineseries
206
Loading...