OEM2400MR User Manual
Installation Procedure
Michelle Zuliani
This document, submitted in confidence, contains proprietary informati on which shall not be
reproduced or transferred t o other documents, disc losed to others, used for manufacturing or
any other purpose without the prior written permiss ion of OMNEX Control Systems ULC.
© Copyright 2009 OMNEX Control Systems ULC.
All rights reserved.
Title - 2 - Revisio n 0.1
Subject
Revision History
Revision Author Date Description
0.1 Michelle Zuliani Dec. 29, 2009 Initial Release
Company Confidential: OMNEX Control S ystems ULC.
Title - 3 - Revisio n 0.1
Subject
CONTENTS
1
Introduction................................................................................................................. 4
2 FCC Notice, U.S.A. ...................................................................................................... 4
3 IC Notice, Canada ....................................................................................................... 4
4 RF Exposure Information.............................................................................................. 4
Company Confidential: OMNEX Control S ystems ULC.
Title - 4 - Revisio n 0.1
Subject
1 Introduction
The OEM2400MR transceiver module is not sold separately as a stand alone device. It is
intended to be used as par t of a complete OMNEX telemetry device and in the user manual
for any device containing the m odule will be included the text from the f ollowing page.
This manual is for the use of professionals to guide them in the installation, operation and
basic system maintenance of the equipment covered.
2 FCC Notice, U.S.A.
OEM-2400-MR complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device m ay not cause harmful interference, and (2) this device must
accept any interference received, including int erference that may cause undesired operat ion
Caution - Changes or modif ications not expressly approved by the OMNEX Control Sys tems
ULC will void the user’s authority t o operate the equipment .
3 IC Notice, Canada
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired operation of
the device.
To reduce potential radio interference to other users, the antenna type and its gain should be so
chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that permitted for
successful communication.
4 RF Exposure Information
READ THIS INFORMATION BEFORE INSTALLING THE OEM900MR
This product is intended for fixed installation applications. In order to comply with FCC/ISC
adopted RF exposure requirement s, installation of this transm itter system's antennas must be
performed in a manner that will provide at least 20 cm (7.88 inches) clearance from the
antenna to any user or member of the public.
OEM-2400-MR was certified with a Linxs Technologies ANT-2.4-SW-CT-RPS ½ wave dipole
antenna with a 46 cm (18 inch) cable.
The maximum radiated output power of these antennas satisfies the maximum permissible
exposure (MPE) limits as specified in §1.1310 of FCC regulations for general
population/uncontrolled ex posure as long as the minimum separat ion distance of 20 cm (7.88
inches) between the radiating element and the person is maintained
Company Confidential: OMNEX Control S ystems ULC.
Loading...