Cool Space BLIZZARD50, CS6-50-VD Operation And Maintenance Manual

Operation and Maintenance Manual

BLIZZARD

CS6-50-VD

120V/60HZ

50

1.0 Introduction

1

2.0 Unpacking your COOL- SPACE®

1

3.0 Set-up of COOL-SPACE® unit

1 3.1 Connecting the water supply

1 3.2 Connecting the electrical supply

2

4.0 Operating procedures

3

4.1 Filling the unit with water

3 4.2 Starting the fan

4 4.3 Starting the pump and adjusting the water flow

4

5.0 Maintenance and storage

4

5.1 Removing the cooling media & accessing the inside of the unit

4 5.2 Daily maintenance

5 5.3 Periodic maintenance

5 5.4 Storage

5 6.0 Troubleshooting/Repair

6 6.1 Troubleshooting

6 6.2 Repair procedures

9 6.3 Technical support

9 7.0 Warranty

10

7.1 Warranty form

10

7.2 Warranty parts

10

7.3 Optional accessories and replacement parts

10

CS6-50-VD

Operation & Maintenance Manual

Table of Contents:

Due to continuous product innovations, we reserve the right to change product
specification without due notice.

Signal Word Definitions

DANGER indicates an imminently hazardous situation which,
if not avoided, WILL result in death or serious injury.

WARNING indicates a potentially hazardous situation which,
if not avoided, COULD result in death or serious injury.

CAUTION indicates a potentially hazardous situation which,
if not avoided, MAY result in minor or moderate injury.

IMPORTANT indicates a potentially hazardous situation
which, if not avoided, MAY result in property damage.

shipping company immediately.

psi. This will cause permanent damage to the unit.

1.0 Introduction

®

COOL-SPACE
manufactured in Indiana.

The COOL-SPACE
cooler.

2.0 Unpacking your COOL-SPACE

Carefully examine the carton for damage before opening. If the carton is damaged notify the

is a patented and registered Trademark of Hale Industries, Inc. and

®

unit is a compact, self-contained, high-efficiency portable evaporative

®

unit

®

3.0 Set-up of the COOL-SPACE

The COOL-SPACE

®

unit is factory tested and ready to use. The unit should be placed on a

unit

level surface, and the casters locked to prevent inadvertent movement. Follow instructions
below to connect water and electrical supply.

3.1 Connecting the water supply

Do not connect the COOL-SPACE® unit to any water source where water pressure exceeds 120

The COOL-SPACE® unit comes equipped with a female garden hose water source connection.
Attach the unit to a standard garden hose outlet for a water source. It is not recommended that
the unit be attached to any water source with operating pressures above 120 psi. If you have
purchased the optional portable water tank, use a standard garden hose (not provided) to
connect the tank to the cooler.

1

3.2 Connecting the electrical supply

volt, and 60 Hz circuit.

Do not exceed the amperage ratings of the extension cord. Undersized extension cords result in

THE WARRANTY.

CS Model Number

Volts ± 10%

Frequency (Hz)

Running Amps

CS6-50-VD

120

60

8.2

Length In

Feet

Cord Size

16 Ga

14 Ga

12 Ga

10 Ga

0-50

13 A

18 A

25 A

30 A

50-100

10 A

13 A

18 A

25 A

The COOL-SPACE® unit should be plugged into a fused or circuit breaker protected 20 amp, 120

All models utilize standard 120-volt power supply. The unit should be plugged into a fused or
circuit breaker protected 20 amp, 120 volt, 60 Hz circuit.

Table 1 shows the amperage requirements for the specific models. If an extension cord is
required, refer to Table 2 for the proper 3-conductor heavy-duty cord required.

excessive drops in voltage, which cause the electric motors to generate excessive heat. This
condition results in inefficient motor operation and premature motor failure, WHICH WILL VOID

Table 1. Electrical Requirements

Table 2. Cord size requirement based on length and max amp draw

A: Amps at 120 volt (de-rate for lower voltage)

2