COOLSHIRT?SYSTEMS MobileCool BP2 Operating Instructions Manual
MobileCool BP2
Congratulations on your purchase of the world’s finest Personal Cooling System
The COOLSHIRT MobileCool BP2 is an active personal cooling system comprising two main
components; a cooling garment with patented non-kink tubing attached and a backpack that
contains a rechargeable Lithium battery pack, battery charger, pump, ice/water bladder and
an on/off switch.
The garment and backpack are connected after donning by a set of quick-disconnect fittings. When
connected together, the garment tubing and backpack bladder form a closed loop of coolant (water)
that is circulated via a pump and battery pack.
Please inspect your purchase to ensure that your system contains the components
listed below. If there are any discrepancies, please contact COOLSHIRT SYSTEMS
Customer Service at 800-345-3176 immediately.
Included with your system:
Quantity
_________ 1
_________ 1
_________ 1
_________2
Part #
2001-0005
5004-0001
5004-0002
5012-0031
Description
MobileCool BP2 Cooling Unit with internal pump
Rechargeable Battery 7 Hour
Battery Charger
Endurance Ice - 24 Ounce
All products are guaranteed for one year from the initial date of purchase for
defects in material and workmanship. If you have any questions, please call
COOLSHIRT SYSTEMS Customer Service at (800) 345-3176. We appreciate your interest
in our personal cooling products.
© 2016 COOLSHIRT SYSTEMS, 170 Andrew Drive, Stockbridge GA 30281
Office : 800-345-3176 Fax: 678-289-4325 www.coolshirt.com
Operating Instructions:
1. Charge the battery pack with the supplied battery charger:
a. The battery pack is located in a pouch on the inside of the backpack, at the top
b. The battery pack can be left in place for charging or removed from its pouch.
c. Simply detach the wire terminal from the battery pack and attach the charger to the
battery at the same terminal location
d. The first charge will take several hours, then a few hours for subsequent charges. A
solid green light on the charger indicates the charge is complete.
MobileCool BP2
2.
3.
4.
5. Priming the System:
Place Endurance Ice in freezer until frozen solid. Place Endurance ice back in
water bladder. NOTE: COOLSHIRT recommends putting ice cubes in the
bladder with Endurance Ice
Re-install the battery pack.
Add 1/2 ounce of Maintenance Additive (5003-0001) then fill bladder with enough cold
water to cover the pump then seal the bladder.
a. On a flat surface lay out the garment and backpack such that the quick disconnect fittings
are facing each other.
b. Prop up the backpack such that the water in the bladder settles at the bottom of the
bladder (ie: toward the pump at the bottom of the backpack).
c. Connect the garment and backpack together using the quick disconnect fittings.
d. Using the toggle switch, turn on the system and allow it to run for a few minutes, taking
note that the water coolant is moving throughout the garment. Turn the system off and
inspect the bladder to see if it is filled half-way with water. If not filled half-way, top off as
required.
6. Close the backpack flap by using the dual zipper pull.
7.
Putting the system on:
•
Put on the garment and backpack. For optimum cooling performance, the garment should
fit snug to the body and be situated against the skin, beneath all other clothing.
• Connect the fittings from the garment and backpack. The fittings will ‘click’ upon a good
connection.
Loading...