CoolLED pE-100 Series Quick Start Manual

pE-100 series

Quick Start Guide

This guide should provide some basic information on the setup and operation
of the CoolLED pE-100 Illumination System.

Before operating this product please read and observe the advice given in the
safety section of the full User Manual.

For more detailed information on the full range of options and functions
please see the full User Manual.

DOC-015 Iss 1 1

pE-100 Light
Source

pE-100
Control Pod

pE-100
Power Supply

Epi-Fluorescent port

Transmitted (Brightfield) port

1. Contents

A typical pE-100 (direct fit)
order will include the parts
shown. A microscope
adaptor that was specified
when ordering will be
fitted to the pE-100 Light
Source. A mains power
cable for the specified
region of use shall also be
included (not pictured).

If the liquid light guide
version is being used then
a specified light guide will
be fitted.

The fibre version of the pE-100 is a fixed module that allows connection to any SMA
terminated fibre. An appropriate fibre can be ordered through CoolLED if required.

2. Fitting the Light Source to a microscope

Attach the Light Source to the specified port of the microscope (Direct fit).

If using a liquid light guide version, attach to the microscope with appropriate
collimating optics.

DOC-015 Iss 1 2