Coolix MPK-09CRN2, MPK1-09CRN1, MPK1-12CRN1 Instructions For Use Manual

MOBILES KLIMAGERÄT MOBILE AIR-CONDITIONER CONDIZIONATORE PORTATILE CLIMATISEUR MOBILE MOBIEL AIRCOTOESTEL

MPK-09CRN2 / MPK1-09CRN1 / MPK1-12CRN1

DE
EN
IT
FR
NL

22

EN

23

INFORMATION 3
SAFETY INSTRUCTIONS 24
DESCRIPTION OF APPLIANCE 26
ACCESSORIES 27
OPERATION PANEL 28
INSTALLATION AND START-UP 30
INSTRUCTION FOR USE 32
WATER TANK 33
INSTALLATION 35
CLEANING, MAINTENANCE AND STORAGE 37
TROUBLESHOOTING 38
WEEE 39
PURCHASE TERMS AND CONDITIONS/WARRANTY 40

INSTRUCTIONS FOR USE

24

CAUTION

DEAR CUSTOMER,

Thank you for buying a product that was developed and checked for the highest claims. Please read the use instructions
document carefully before the first start up, so that you may get to know all the functions of this appliance. Keep the use

instructions document for reference whenever required.

INFORMATION

In summer, one feels good at a temperature between 24°C and 27°C, and a relative humidity of about 50%. Air-conditioners
serve the purpose of recreating this condition even at higher external temperatures and higher humidity levels in the room
by removing humidity and heat from the air in the room.

Unlike permanently installed air-conditioners, mobile models have the advantage that they can be moved from one room to
another and can be transported to another building.

SAFETY INSTRUCTIONS

1. Do not operate this appliance if it is damaged or has damages, or if it does not function properly. Disconnect the power
plug from the power socket.

2. Install the appliance at a place where children cannot reach it.

3. Do not use the appliance:
A: In the vicinity of heat sources, e.g., heater or a heating appliance, clothes dryer, etc.
B: At places where oil and water can be splashed.
C: At places that are directly exposed to the rays of the Sun.
D: In the vicinity of bathtubs, showers or swimming pool.
E: In a greenhouse.
F: In the vicinity of easily combustible gases and substances.
G: Behind curtains or other objects or obstacles that can have an adverse effect on the air circulation.
H: In the open.

4. Always place the appliance in the upright position, so that the compressor can function properly.

5. If the power cable of the appliance is damaged, it must be repaired at a workshop licensed by the manufacturer, as
special tools are required.

EN

25

6. Always remove the power plug from the power socket when the appliance is not in use, or when it is moved, touched or
cleaned. Do not yank the cord to disengage the power plug.

7. Always switch the appliance off before disconnecting the power plug from the power socket by activating the POWER
key on the operation panel.

8. Do not remove the water tank when the appliance is in operation.

9. Never insert your finger or other external bodies in the grid or openings. This can lead to overheating, fire or electric
shock. Warn children about these dangers.

10. Do not dip the appliance in water or other liquids and do not shake water or other liquids over the appliance or in the air
inflow and outflow apertures.

11. The appliance must be cleaned regularly. Please observe the cleaning instructions in this context. The appliance must be
disconnected from the power supply before being cleaned.

12. The appliance should not be covered.

13. Do not use insecticide sprays or other sprays on the appliance that can cause fire.

14. The appliance does not contain components that require maintenance by the user. You must send the appliance to the
manufacturer or to Customer Service, if the appliance or the power cable is damaged.

15. Please empty the water tank before transporting the appliance. The appliance must be disconnected from the power
supply for this purpose.

16. For server room cooling, please engage a technician to ensure that the efficiency of the appliance matches your require­ ments.

26

DESCRIPTION OF APPLIANCE

1. Operation panel

2. Vertical ventilation flap

3. Direction regulator

4. Horizontal ventilation flap

5. Supporting handle (on both sides)

6. Water tank

7. Rollers

8. Air filter

9. Fastening tape for power cable

10. Outlet plug

11. Hot air outlet

12. Air entry inlet

13. Bottom outlet plug

1

2

3

4

5

6

7

8

9

10

11

12

13

EN

27

Check whether all the accessories are there in the packaging and read the use instructions to learn how these are to be used.

ACCESSORIES

Figure Designation Number

Exhaust cable 1

Adapter A (for permanent cable mounting) 1

Adapter B (for provisional cable mounting) 1

Expansion plug 4

Tape for fastening power cable 1

Emptying hose (continuous discharge)
(Not available in some models)

1

Emptying hose (connected to the water tank) 1

Window panel set 1

28

OPERATION PANEL

3

1

2

4

5

7

8

3

1.

You can switch the appliance on by pressing , the adjacent control light lights up now.

Press the key again to deactivate the appliance, the control light goes off.

2.

key: This key is used to determine when the appliance will be switched on automatically.
key: By pressing this key you can determine when the appliance will be switched off automatically.
The control lights on the two keys indicate whether these functions were selected.

3.

key: These keys are used to adjust the desired cooling temperature. The temperature increases by 1°C each

time you press the key, the temperature decreases by 1°C each time you press the key.

4.

key: You can select the mode of the appliance by pressing this key. The mode changes each time you press this
key in the following sequence: Cool – Dehumidify – Fan – Heat.
The currently set mode can be identified from the control light that is illuminated next to the symbol. The Heat mode is
to be selected only in appliances that are equipped with the heating function.

Timer

2

6

EN

29

5. key: You can select the fan speed in the Cool and Fan modes by pressing this key. The speed changes
in the following sequence each time you press the key: Low – Medium – High.
The currently set speed can be identified from control light that lights up next to the symbol.

6.

control light: It lights up when the water tank is full or the water tank has not been inserted correctly. The

appliance stops the operation automatically. The water tank must be emptied or positioned correctly.

7. Digital Display: The set temperature is displayed here. The current room temperature is displayed in the Ventilate and
Dehumidify modes. The set values are displayed here when the timer function is set.
Note: The temperature can be displayed and set in °C or °F. Please press the

and keys simultaneously to

change the display. You can view whether the display is in °C or °F with the help of the corresponding control light.

8. Signal receiver for remote control. This receiver does not have any function in appliances that do not support remote
control.

30

INSTALLATION AND START-UP

1. Read all the instructions carefully before commissioning the appliance. Observe the safety instructions of this user
manual in particular.

2. The appliance must be in the upright position for at least 24 hours before start up. This condition is applicable most of
all after transportation.

3. Place the appliance on a firm, even surface. Ensure that it is stable so that the appliance does not fall down or topple
over. The discharged water can damage furniture and floor covers.

4. This appliance is equipped with a water tank which is fastened with a belt in the factory to protect the water level switch
during transportation. Take the water tank out and remove the fastening tape and replace the water tank in its initial
position before the first start-up. Do not push or apply sudden force on the tank, as this could lead to faults in the
appliance. Information about the correct handling of the water tank is available in the Chapter entitled “Water Tank” in
this use instructions document.

5. Maintain a safety distance of about 30 cm at the front and rear side of the appliance from other objects. The appliance
should not be placed under tables or in cabinets, because then the airflow is restricted.

m

c

0

3

0

3 c

m

4

5

EN

31

6. Before operating the appliance, please ensure that the air inflow and outflow apertures are not covered. The air exhaust
nozzle must always be freely accessible when the appliance is in operation.

7. Removable covers and tanks must be inserted correctly before switching the appliance on.

8. Position the exhaust air hose and the adjustable window panel set as illustrated in the adjacent figures.

9. Detailed information about the installation of the exhaust air hose and the window panel is available in the Chapter
entitled “Installation” in this use instructions document.

10. Do not use any extension cable, a multi-socket that is also used by other electrical appliances or a continuous speed
regulator. This can lead to overheating, causing a fire.

11. Connect the dehumidifier only to a functioning, single-phase, earthed socket with the mains voltage specified on the
ratings plate. The wall socket should be easily accessible.

12. Unwind the power cord fully and insert the power plug into the power socket. Not unwinding the coiled cord can lead to
overheating, causing a fire. Do not touch the power cable with wet hands.

13. The POWER control light flashes.

14. Now press the

power key to activate the appliance. Press the key again to deactivate the appliance.

8

8

NOTE

Wait for 3 minutes before restarting the appliance after it is deactivated unintentionally (power failure) or
intentionally.