Wireless Outdoor Drone Helicopter
Main feature:
Descriptions of parts:
FCC WARNING
The device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions :
This device may not cause harmful interference, and,
This device must accept any interference received, including interference that may cause undesired operation.
CAUTION: Please note that changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one of more of the following measures :
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver;
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected;
- Consult the dealer or an experienced radio/TV technician for help.
Remote controller battery installation:
Install or replace the batteries:
AA Size
compartment
BATTERY PRECAUTIONS:
Use only the size and type of batteries specified.
Be sure to follow the correct polarity when installing the batteries.
Reversed batteries may cause damage to the device.
Do not mix different types of batteries together (e.g. Alkaline and
Carbon-zinc) or old batteries with fresh ones.
If the batteries in the device are depleted or the device will not be used
for a long period of time, remove the batteries to prevent damage or
injury from possible battery leakage.
Do not try to recharge batteries not intended to be recharged; they can
overheat and rupture.
X AA Size batteries
(Follow battery manufacturer’s directions.)
6. Do not dispose of batteries in fire, batteries may explode or leak.
7. Clean the battery contacts and also those of the device prior to
battery installation.
8. Remove discharged batteries from the product and dispose/recycle
in compliance with all applicable laws.
Motive force battery using instructions:
(included) (pre-installed).
finished
white plug to white jack
provided
approximate 90
Flying:
Install the battery in the UFO (pre-installed) (see pic. 1) and connect
the power of UFO (see pic. 2). Put the UFO on the flat floor steadily.
pic.1
(pre-installed) (black plug to black jack)
Turn on the remote controller by pushing Power switch up. The Power
light will flash and you will hear Di sound three times. Push the Throttle
stick up and then pull down to bottom position, the Power light will light
and you can hear a Di sound. Then, the remote controller has connected
to the UFO.
pic.2
Information:
Flying controll:
High and low speed mode and roration mode:
Aerial somersault:
Trimmer reset:
Rolled the joystick to below pic.position and on hold 5 seconds,UFO lights
flashing and stay light,then all tuning is reset.
Accessories included:
1 x Remote Controller
1 x Lithium battery (pre-install in battery shelf)
1 x AC Adaptor
4 x Blades(additional)
1 x Instruction manual
R
products are satisfaction guaranteed
or your money back.
R
Loading...