Cookworks HB956SH6PB Instruction manual

Stainless Steel Hand Blender Set

Model No. HB956SH6PB

Care & Instruction Manual

For household and indoor use only

Please read these instructions before use and retain for

future reference

ISSUE-1 24/7/2017 1

Electrical safety
 You should only plug the appliance into a 220V‐240V AC, 50Hz

supply. Connecting it to other power sources may damage the
appliance and will invalidate the guarantee.

 Switch off and unplug when not in use and before assembling,

disassembling, changing accessories or cleaning the appliance.

 This appliance shall not be used by children Keep the appliance

and its cord out of reach of children.

 This appliance can be used by persons with reduced physical,

sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and understand
the hazards involved.

 Children shall not play with the appliance.
 Keep motor housing, cable, and plug dry and away from areas

where it is likely to get splashed. Never immerse in water.

 Do not pull on the cable to disconnect from the mains supply.
 Do not operate the appliance if damaged or after it malfunctions.

In the event the supply cord is damaged, in order to avoid a
hazard it must only be replaced by a qualified service engineer,
with a suitably approved part.

 This appliance must be positioned so that the plug is accessible

and the plug socket is within easy reach of the power cord.

ISSUE-1 24/7/2017 2

Warning!
 This appliance is intended exclusively for use in domestic

households. It is not suitable for commercial use.

 Only use with the parts supplied and fully assembled.
 Never place hands or utensils into the blending container or near

the blender head when in use. Only use a scraper when the
blender is not in operation.

 Do not cover the hand blender and allow the motor housing to

cool fully before storing.

 Do not leave unattended during use.
 Do not overfill the beaker or mini chopper.
 The hand blender and chopper blades are sharp, take care when

emptying and cleaning.

 Do not attempt to operate the mini chopper without the

protective lid in place.

 This appliance can cause personal injury if misused.

Food safety

 Keep raw meat and poultry separate from cooked foods.
 Always wash hands after handling raw meat and poultry, before

handling any ready to eat foods.

 Wipe and disinfect surfaces that have been in contact with raw

meat and poultry.

 Use separate utensils for handling raw meat/poultry and cooked

food or wash them thoroughly between use.

ISSUE-1 24/7/2017 3

Parts

1. On / Off button

2. Turbo button

3. Motor housing

4. Collar

5. Blender stem

6. Blender head

7. Power cable

IMPORTANT:
Your hand blender is equipped
with a safety feature, where the
blades / whisk will not operate
unless the collar / lid and motor
housing are fully locked.

ISSUE-1 24/7/2017 4

8. Chopper lid

9. Chopper blade

10. Bowl

11. Whisk gearbox

12. Whisk

13. Beaker

Basic operation

1. Clean all parts thoroughly before first use.

2. Align the small arrow on the neck of the accessory with the
‘unlocked’ padlock symbol at the base of the motor housing and
twist to align the arrow with the ‘locked’ padlock symbol.

3. Fully unwind the motor housing cable, plug in and switch on.

4. Follow the use instructions for the specific accessory (see the
following sections).

5. Hold down the motor housing ON/OFF or TURBO button to start
the blender working. See the following sections for maximum use
times for each accessory.

6. To switch off, release the speed button and allow the blade /
whisk to come to a complete stop before checking the
consistency of the mix / chop. If satisfactory, remove the
accessory from the mix.

7. To stop or interrupt the blending process, release the speed
button or turn off at the mains.

ISSUE-1 24/7/2017 5

Fig. 2

USING THE HAND BLENDER

1. Carefully remove the plastic blade guard and fit
the hand blender to the motor housing and lock
into position (fig.2).

2. Place the ingredients to be blended into the
beaker or another suitable wide container with
high sides. Do not overfill the beaker (max
1100ml). The use of the beaker is not
recommended to blend thin liquids.

3. Place the container on a stable surface.

4. Place the head of the hand blender below the
surface of the ingredients. Do not immerse the
stem beyond the max level shown in the diagram
opposite.

5. Connect to the mains, select the operation speed

Max
insertion
level

of choice and when using the hand blender, mix
for a maximum of 1 minute. If further blending
is required, wait 1 minute before restarting the
blender.

6. After a total of 3 of the above cycles, the blender
should be rested for 20 minutes.

7. Blend to the desired consistency – see step 6
onwards under ‘basic operation’.

Note

 Do not run the blender dry (without the head covered by liquid).
 To avoid splashing, ensure head of the blender is within the

blending container and the head is covered before starting or
removing.

 Do not add extra ingredients into the beaker / blending container

when the blender is operating.

 If using to puree fruit and vegetables, remove the skins, peel or

stones and cut into small pieces before blending.

 If blending ingredients in a saucepan (e.g. to purée soups),

remove the saucepan from the heat to protect the blender from
damage.

ISSUE-1 24/7/2017 6

Max

Fig. 3

Using the whisk

1. Fit the whisk head into the gear box and then fit

the assembly onto the motor housing and lock
into position (fig.3).

2. Place the ingredients to be whisked into the

beaker or a high sided bowl and place the bowl
on a stable surface. Do not overfill the beaker
(max 1100ml).

3. Place the head of the whisk partially below the

surface of the ingredients. Do not immerse the
head beyond the max level shown in the
diagram opposite.

4. Connect to the mains, select the operation

speed of choice and when using the whisk, mix
for a maximum of 3 minutes. If further whisking
is required, wait 1 minute before restarting.

5. After a total of 3 of the above cycles, the whisk

should be rested for 20 minutes.

6. Whisk to the desired consistency – see step 6

Max
insertion
level

onwards under ‘basic operation’.

Note
 To avoid splashing, ensure head of the whisk is within the

whisking bowl before starting or removing.

 Do not add extra ingredients into the beaker / blending container

when the whisk is operating.

ISSUE-1 24/7/2017 7

Using the chopper

1. Carefully remove the plastic blade guard and place the blade
onto the metal pin in the base of the chopping bowl (fig.4).

2. Place the food to be chopped or blended into the bowl on top of
the blades, do not exceed the max level (600ml) marked on the
bowl.

3. Fit the lid onto the motor housing and lock into position (fig.5).

4. Fit the lid onto the bowl (fig.6). Do not try to use the chopper
without the lid in place.

5. Connect to the mains, select the operation speed of choice and
when using the mini chopper, chop for a maximum of 1 minute.
If further blending is required, wait 1 minute before restarting.

6. After a total of 3 of the above cycles, the chopper should be
rested for 20 minutes.

7. Chop to the desired consistency – see step 6 onwards under
‘basic operation’.

Note:
 Do not run the chopper empty (without the blade covered by

food).

 If using to chop fruit and vegetables, remove the skins, peel or

stones and cut into small pieces before chopping. It may be
necessary to add some water when chopping vegetables or fruit.

 If using to chop meat, cut the meat into small pieces before

chopping and do not add more than 200g to the chopping bowl.

Fig. 4 Fig. 5 Fig. 6 Fig. 7

ISSUE-1 24/7/2017 8

Cleaning
Clean the hand blender set after each use.

1. Switch off and unplug.

2. Remove the mixing accessories and wash these in hot water with

a little washing up liquid. Rinse and wipe dry. Do not immerse
the gear box portion (the part that connects to the motor
housing) of the chopper lid, whisk and hand blender in water.

3. Wipe the outside of the motor housing and cable with a damp

cloth and then wipe dry. Do not use detergent or abrasives as
these may scratch the surface

4. Never immerse the motor housing, cable or plug in water.

5. No part of this appliance is suitable for dishwashers.

Technical specification
Rated voltage 220-240V AC 50/60Hz
Power consumption 600W
Class rating 2 (double insulated)
BS 1362 fuse 3A

ISSUE-1 24/7/2017 9

If you encounter any problems

Produced in China for

Plug / Wiring advice
The wires in this mains lead are coloured in accordance with the
following UK electrical code: BLUE = NEUTRAL

BROWN = LIVE
Non-rewireable plug
This appliance may be fitted with a “non‐rewireable” plug. If you
need to change the fuse in a “non‐rewireable” plug, the fuse cover
must be refitted. If the fuse cover is lost or damaged, the appliance
must not be used.

Rewireable plug
The colours of the wires in the mains lead of this appliance may not
correspond with the coloured markings identifying the terminals in a
rewireable plug. Rewireable plugs should only be replaced by a
suitably competent person. If in doubt, consult a qualified
electrician.

The BLUE wire must be connected to
the terminal marked with the letter N

The BROWN wire must be connected to
the terminal marked with the letter L

Recycling electrical products

This marking indicates that this product should not be
disposed with other household wastes throughout the EU. To
prevent possible harm to the environment or human health
from uncontrolled waste disposal, recycle it responsibly to
promote the sustainable reuse of material resources. To return
your used device, please use the return and collection systems
or contact the retailer where the product was purchased. They
can take this product for environmental safe recycling.

with this product please call our
customer care team on
0345 640 30 30

ISSUE-1 24/7/2017 10

Argos Limited,
489 – 499 Avebury Boulevard
Central Milton Keynes
MK9 2NW. UK.

ISSUE-1 24/7/2017 11