ISSUE-1 9/11/2017
1
1.5 Litre Blender
Model No. BL9295G-GS
Care & Instruction Manual
Please read these instructions before use and retain for
For household and indoor use only
future reference
ISSUE-1 9/11/2017
2
Electrical safety
You should only plug the appliance into a 220V‐240V AC, 50Hz
supply. Connecting it to other power sources may damage the
appliance and will invalidate the guarantee.
Switch off and unplug when not in use and before assembling,
cleaning or dismantling the appliance.
This appliance shall not be used by children. Keep the appliance
and its cord out of reach of children.
This appliance can be used by persons with reduced physical,
sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the
hazards involved.
Children shall not play with the appliance.
Keep motor housing, cable, and plug dry and away from areas
where it is likely to get splashed. Never immerse in water.
Do not cover or block the ventilation holes.
Do not pull on the cable to disconnect from the mains supply.
Do not operate the appliance if damaged or after it malfunctions.
In
the event the supply cord is damaged, in order to avoid a
hazard it must only be replaced by a qualified service engineer,
with a suitably approved part.
This appliance must be positioned so that the plug is accessible
and the plug socket is within easy reach of the power cord.
ISSUE-1 9/11/2017
3
Warning!
This appliance is intended exclusively for use in domestic
households. It is not suitable for commercial use.
Always unplug the motor housing of the blender if unattended
and before assembling, disassembling or cleaning.
Only use with the parts supplied and fully assembled.
Never place hands or utensils inside the jug whilst the blender
is in use. Only use a scraper when the blender is not in operation.
Do not cover the blender and allow the motor housing to cool
fully before storing.
Never use hot liquids in the blender jug, always allow liquids to
cool to room temperature before blending.
Do not
fill
above maximum level marked (1500ml) or use without
the lid and stopper in place as the contents may be ejected when
the blender
is
started.
Do not leave unattended during use.
The blender blades are sharp, take care when emptying the jug
and cleaning.
This appliance can cause personal injury if misused.
Parts
ISSUE-1 9/11/2017
4
IMPORTANT:
Your blender
blades
will
is
equipped with a safety feature, where the
not operate unless the base of the jug and
motor housing are fully locked and the lid correctly fitted.
ASSEMBLY
Fig.1
1. Fit the seal onto the underside of the jug and fit the blade
assembly as shown (fig 1.). Turn the blade assembly anticlockwise to secure.
2. Fit the lid onto the top of the jug (fig 2). To fit the stopper, align
the lugs on the side of the stopper with the notches in the lid;
insert the stopper and twist clockwise to secure.
3. Align the lugs on the side of the jug with the notches in the motor
assembly and fit the jug onto the motor housing (fig.3).
TO USE
1. Clean thoroughly before use.
2. Place the blender base on a stable surface, check that the speed
control knob is in the OFF(0) position, fully unwind the cable and
plug in.
Fig.2
Before blending,
add food to be
blended into the
jar.
Fig.3
ISSUE-1 9/11/2017
5
3. Ensure all ingredients are close to room temperature. Never use
hot ingredients as this can cause the glass jug to shatter.
4. Place the ingredients into the glass jug and check that the level is
not above the maximum level marked (1500ml).
5. Fit the lid, secure the stopper and place the jug onto the motor
housing.
6. Using the speed control knob, select the appropriate blender
speed for your ingredients. A slower mix will be obtained by
selecting the lowest speed setting (1) and a faster mix by
selecting the higher setting(2).
7. Mix for a
maximum
of 3 minutes. If further mixing is required,
wait until the blender has cooled to room temperature before
restarting.
8. Switch off; allow the blade to stop spinning before checking the
consistency of the mix. If satisfactory, remove the jug.
9. To use blender on pulse, turn and hold the speed switch to the ‘P’
position for short intervals. The blender will operate at full speed,
when the desired mix is achieved, release the switch.
10. To stop or interrupt the blending process switch the appliance off
by turning the speed control knob to OFF(0) or by turning off at
the mains.
Notes:
Do not run the blender with the container empty or with solids
only.
Do not use without the seal fitted.
For some types of mixes it may be necessary to fill above the
minimum (250ml) to obtain the most efficient mixing.
The stopper
is
graduated and may be used as a measuring cup.
CLEANING
Clean the blender after each use.
1. Switch off and unplug.
2. The jug, lid and stopper may be washed in hot water with a little
washing up liquid taking care not to handle the blades. Rinse and
wipe dry.
Not suitable for dishwashers.
3. To separate the blade assembly from the glass jug, firmly grasp
the base assembly on the underside of the jug and twist the
ISSUE-1 9/11/2017
6
assembly clockwise to remove. Lift off the silicon washer. Please
note the blade assembly may be difficult to remove the first time.
4. Wipe the outside of the motor housing with a damp cloth; do not
use detergent or abrasives as these may scratch the surface.
5. Never immerse the motor housing, cable or plug in water.
Note:
Please note the blade cannot be removed from the base of the
jug.
Technical specification
Rated voltage
Power consumption
Maximum work time
Class rating
BS 1362 fuse 5A
Capacity
220-240V AC 50/60Hz
500W
3 minutes
2 (double insulated)
1.5 Litre
ISSUE-1 9/11/2017
7
Plug / Wiring advice
If you encounter any problems Produced in China for
The wires in this mains lead are coloured in accordance with the
following UK electrical code:
Non-rewireable plug
BLUE = NEUTRAL
BROWN = LIVE
This appliance may be fitted with a “non‐rewireable” plug. If you need
to change the fuse in a “non‐rewireable” plug, the fuse cover must be
refitted. If the fuse cover
is
lost or damaged, the appliance must not
be used.
Rewireable plug
The colours of the wires in the mains lead of this appliance may not
correspond with the coloured markings identifying the terminals in a
rewireable plug.
Rewireable plugs should only be replaced by a
suitably competent person. If in doubt, consult a qualified
electrician.
The BLUE wire must be connected to
the terminal marked with the letter N
The BROWN wire must be connected to
the terminal marked with the letter L
Recycling electrical products
This marking indicates that this product should not be
disposed with other household wastes throughout the EU. To
prevent possible harm to the environment or human health
from uncontrolled waste disposal, recycle it responsibly to
promote the sustainable reuse of material resources. To return
your used device, please use the return and collection systems
or contact the retailer where the product was purchased. They
can take this product for environmental safe recycling.
with this product please call our Argos Limited,
customer care team on
Boulevard 0345 640 30 30
489 – 499 Avebury
Central Milton Keynes
MK9 2NW. UK.
ISSUE-1 9/11/2017
8
Loading...