Page 1
1.5 Litre Blender
Model No. BL9292-GS
Care & Instruction Manual
For household and indoor use only
Please read these instructions before use and retain for
Issue 1 30/6/2017
future reference
1
Page 2
Electrical safety
You should only plug the appliance into a 220V‐240V AC, 50Hz
Switch off and unplug when not in use and before assembling,
This appliance shall not be used by children. Keep the appliance
This appliance can be used by persons with reduced physical,
Children shall not play with the appliance.
Keep motor housing, cable, and plug dry and away from areas
Do not cover or block the ventilation holes.
Do not pull on the cable to disconnect from the mains supply.
Do not operate the appliance if damaged or after it malfunctions.
This appliance must be positioned so that the plug is accessible
supply. Connecting it to other power sources may damage the
appliance and will invalidate the guarantee.
cleaning or dismantling the appliance.
and its cord out of reach of children.
sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and understand
the hazards involved.
where it is likely to get splashed. Never immerse in water.
In the event the supply cord is damaged, in order to avoid a
hazard it must only be replaced by a qualified service engineer,
with a suitably approved part.
and the plug socket is within easy reach of the power cord.
Issue 1 30/6/2017
2
Page 3
Warning!
This appliance is intended exclusively for use in domestic
Always unplug the motor housing of the blender if unattended
Only use with the parts supplied and fully assembled.
Never place hands or utensils inside the jug whilst the blender is
Do not cover the blender and allow the motor housing to cool
Never use hot liquids in the blender jug, always allow liquids to
Do not fill above maximum level marked (1500ml) or use without
Do not leave unattended during use.
The blender blades are sharp, take care when emptying the jug
This appliance can cause personal injury if misused.
IMPORTANT:
Your blender is equipped with a safety feature, where the
blades will not operate unless the base of the jug and
motor housing are fully locked and the lid correctly fitted.
households. It is not suitable for commercial use.
and before assembling, disassembling or cleaning.
in use. Only use a scraper when the blender is not in operation.
fully before storing.
cool to room temperature before blending.
the lid and stopper in place as the contents may be ejected when
the blender is started.
and cleaning.
Parts
Issue 1 30/6/2017
3
Page 4
To use
1. Clean thoroughly before use.
2. Place the motor housing on a stable surface, check that the
3. Place the ingredients to be blended into the jug and check that
4. Fit the lid and stopper to the jug
5. Fit the jug onto the base, align
6. Using the speed switch, select
7. If the blender does not operate
8. Blend for a maximum of 3 minutes. If further blending is
9. After a total of 2 of the above cycles, the blender should be
10. Switch off; allow the blade to stop spinning before checking the
11. To use the blender on pulse, turn and hold the speed switch to
Fig.1
Fig. 2
speed switch is at the off (0) position, fully unwind the cable and
plug in.
the level is not above the maximum level marked (1500ml).
and lock into position (fig. 1).
When correctly fitted the arrows
on the handle and lid will be
aligned and spout will be
covered.
the jug handle with the
‘unlocked’ padlock symbol on
the side of the motor housing
and twist until the handle is
aligned with the ‘locked’ padlock
symbol (fig. 2).
the appropriate blender speed
for your ingredients. A slower
mix will be obtained by selecting
the lower speed setting (1) and a
faster mix by selecting the
higher setting (2).
check that the jug and the lid is
fully locked into position.
required, wait 10 minutes before restarting the blender.
rested for 30 minutes.
consistency of the mix. If satisfactory, remove the jug.
the ‘P’ position for short intervals. The blender will operate at
full speed, when the desired mix is achieved, release the switch.
Issue 1 30/6/2017
4
Page 5
12. To stop or interrupt the blending process switch the appliance off
by turning the speed control switch to ‘0’ or by turning off at the
Do not run the blender with the container empty or with solids
For some types of mixes it may be necessary to fill above the
The stopper is graduated and may be used as a measuring cup.
1. Switch off and unplug.
2. The jug, lid and stopper may be washed in hot water with a little
3. Wipe the outside of the motor housing with a damp cloth; do not
4. Never immerse the motor housing, cable or plug in water.
Please note the blade cannot be removed from the base of the
mains.
Notes:
only.
minimum (250ml) to obtain the most efficient mixing.
Cleaning
Clean the blender after each use.
washing up liquid taking care not to handle the blades. Rinse and
wipe dry. Not suitable for dishwashers.
use detergent or abrasives as these may scratch the surface.
Note:
jug.
Technical specification
Rated voltage 220-240V AC 50/60Hz
Power consumption 500W
Maximum work time 3 minutes
Class rating 2 (double insulated)
BS 1362 fuse 5A
Capacity 1.5 Litre
Issue 1 30/6/2017
5
Page 6
Plug / Wiring advice
The BLUE wire must be connected to
the terminal marked with the letter N
The BROWN wire must be connected to
the terminal marked with the letter L
If you encounter any problems
with this product please call our
customer care team on
0345 640 30 30
Produced in China for
Argos Limited,
489 – 499 Avebury Boulevard
Central Milton Keynes
MK9 2NW. UK.
The wires in this mains lead are coloured in accordance with the
following UK electrical code: BLUE = NEUTRAL
BROWN = LIVE
Non-rewireable plug
This appliance may be fitted with a “non‐rewireable” plug. If you
need to change the fuse in a “non‐rewireable” plug, the fuse cover
must be refitted. If the fuse cover is lost or damaged, the appliance
must not be used.
Rewireable plug
The colours of the wires in the mains lead of this appliance may not
correspond with the coloured markings identifying the terminals in a
rewireable plug. Rewireable plugs should only be replaced by a
suitably competent person. If in doubt, consult a qualified
electrician.
Recycling electrical products
This marking indicates that this product should not be
disposed with other household wastes throughout the EU. To
prevent possible harm to the environment or human health
from uncontrolled waste disposal, recycle it responsibly to
promote the sustainable reuse of material resources. To return
your used device, please use the return and collection systems
or contact the retailer where the product was purchased. They
can take this product for environmental safe recycling.
Issue 1 30/6/2017
6
Page 7
Issue 1 30/6/2017
7
Page 8
Issue 1 30/6/2017
8
Loading...