Kawasaki ZX-9R (98+)
Bike Specific Install Notes and Tips
This is an aftermarket product that fits up different than the stock components, therefore, the ins taller may be required to
set up components and to route lines in the ?best way pos s ible?, which may not always be lis ted on this ?Bike
Specific? ins tallation sheet. In any case, the ins tallation mus t allow the handlebars to reach both steering stops , with
out pulling taught or kinking any lines, and without dam aging any part of the motorcycle
Important Installation Conside rations
Fairing stay restricts rise to less than one inch. If modified and a longer brake
line is added, much more rise could be achieved.
Special Kit Re quirements/Installation Tips
1. Contact - Slight fairing contact is ok as long as the steering stops can be
reached with out damaging the fairing
Restrictions
1. Fairing stay/windshield Frame - restricts rise. If the fiaring stay is modified or
removed, more rise can be achieved.
Line Routing
1. Electrical Lines to be freed from their brackets and or Zip Ties, and run on the
rider's side of the forks
Recommended Riser Trim Length
1. 5.0" Riser Length = Trim Number 8
Recommended parts and re placement line s
1. Hydraulic Brake Line = Stock + 3"
2. Hydraulic Clutch Line Top Fitting - 90 degree face to the side
Loading...