ConvertiBARS YZF-600R User Manual

Yamaha YZF-600R

Bike Specific Install Notes and Tips

This is an aftermarket product that fits up different than the stock components, therefore, the ins taller may be required to

set up components and to route lines in the ?best way pos s ible?, which may not always be listed on this ?Bike

Specific? ins tallation sheet. In any case, the ins tallation mus t allow the handlebars to reach both steering stops , with

out pulling taught or kinking any lines, and without dam aging any part of the motorcycle

Important Installation Conside rations

Special Kit Re quirements/Installation Tips

1. Contact - Slight fairing contact is ok as long as the steering stops can be
reached with out damaging the fairing

2. Zip ties or brackets holding excess electrical lines will need to be cut or removed
to free up extra length.

Line Routing

1. Electrical Lines to be freed from their brackets and or Zip Ties, and run on the
rider's side of the forks

Recommended Riser Trim Length

1. 6.5" Riser Length = Trim Number 11

Recommended parts and re placement line s

1. Hydraulic Brake Line = Stock + 3"

2. Cable Clutch Line - Ok rerouted

3. Cable Clutch Line - Stock + 2"