ConvertiBARS XB12R User Manual

Buell XB12R(08-)

Bike Specific Install Notes and Tips

This is an aftermarket product that fits up different than the stock components, therefore, the ins taller may be required to

set up components and to route lines in the ?best way poss ible?, which may not always be listed on this ?Bike

Specific? installation sheet. In any case, the installation must allow the handlebars to reach both steering stops, with

out pulling taught or kinking any lines, and without damaging any part of the motorcycle

Important Installation Conside rations

Use XB12XT Lines for full rise.

Handlebar Positioning

1. When the bars are in the up position, with the wheel straight, the clamps should
be rotated so the handlebar risers are at approximately the 7 and 5 - O'Clock
positions(as the rider is looking down at the top of the fork tubes) This will allow
clearance with the upper fairing and windshield as you turn stop to stop.

2. The bars work best when the riser is located on the aft side of the forks in both
the up and down positions.

Restrictions

1. Kit works well as a riser, but there are restrictions when converting to a lower
handlebar position.

Line Routing

1. All longer lines routed as stock.

2. Throttle Lines - Stock length - route behind the right fork tube

3. Clutch Line - Stock Length - Route behind fork tube