ConvertiBARS XB User Manual

Buell XB models 2005-07

Bike Specific Install Notes and Tips

This is an afterm arket product that fits up different than the stock components, therefore, the installer may be required to

set up components and to route lines in the ?bes t way possible?, which may not always be lis ted on this ?Bike

Specific? ins tallation sheet. In any case, the installation must allow the handlebars to reach both steering stops , with

out pulling taught or kinking any lines , and without damaging any part of the motorcycle

Important Installation Considerations

For longer clutch cable, use cable from XB12S (lightening). The stock

handlebar mounts restrict positioning to aft of stock only.

Special Kit Re quire ments/Installation Tips

1. A thin Metal ring on each fork tube needs to be removed to allow the Cyclops
clamp to slide further down the fork leg. These rings are located on the fork
tubes, just under the stock handlebar.

2. Contact - Slight fairing contact is ok as long as the steering stops can be
reached with out damaging the fairing

3. Zip ties or brackets holding excess electrical lines will need to be cut or removed
to free up extra length.

Handlebar Positioning

1. When the bars are in the up position, with the wheel straight, the clamps should
be rotated so the handlebar risers are at approximately the 7 and 5 - O'Clock
positions(as the rider is looking down at the top of the fork tubes) This will allow
clearance with the upper fairing and windshield as you turn stop to stop.

Line Routing

1. Throttle Lines - Stock length - route behind the right fork tube