ConvertiBARS VFR-800 User Manual

Honda VFR-800(.98-99)

Bike Specific Install Notes and Tips

This is an aftermarket product that fits up different than the stock components, therefore, the ins taller may be required to

set up components and to route lines in the ?best way pos s ible?, which may not always be lis ted on this ?Bike

Specific? ins tallation sheet. In any case, the ins tallation must allow the handlebars to reach both steering stops, with

out pulling taught or kinking any lines, and without dam aging any part of the motorcycle

Important Installation Considerations

Special dual brake line works with linked braking system. Remove the top line(2

lines with a junction block)and the hard cross over line. The replacement lines
Both bolt at the master cylinder using a double banjo bolt and 3 washers. On
the opposite ends, the line with the male threaded end, attaches to the clutch
side crossover block. The second line attaches directly to the right caliper.

Special Kit Re quirements/Installation Tips

1. Contact - Slight fairing contact is ok as long as the steering stops can be
reached with out damaging the fairing

2. Trimming - Depending on rise and preference, trimming the handlebar length
will allow more rise

3. Moving - Moving the clutch lever, and brake lever toward the center of the
motorcycle will allow greater upper fairing/windshield clearance

Restrictions

1. Triple Clamp Pinch Bolts restrict forword and or aft positioing if using the 8mm
web clamps(ex. 41-875-08). 41mm and 43mm clamps are also offered with a
26mm web distance which locates the riser pipe further outboard avoiding the
pinch bolts.

Recommended Riser Trim Length

1. 5.0" Riser Length = Trim Number 8

Recommended parts and re place ment lines

1. Honda VFR-800(98-99) Stock+75mm length Throttle Lines(Part Numbers, 07­0805, 07-0807. Order from ConvertiBARS

2. Hydraulic Brake Line Top Fitting - 90 degree face to the side

3. Hydraulic Brake Line = Stock + 3"

4. Hydraulic Clutch Line Top Fitting - 90 degree face to the side

5. Hydraulic Clutch Line = Stock + 2"