ConvertiBARS GSX-R1000 User Manual
Suzuki GSX-R1000 (01-02)
Bike Specific Install Notes and Tips
This is an aftermarket product that fits up different than the stock components, therefore, the ins taller may be required to
set up components and to route lines in the ?best way poss ible?, which may not always be listed on this ?Bike
Specific? installation sheet. In any case, the installation must allow the handlebars to reach both steering s tops , with
out pulling taught or kinking any lines, and without damaging any part of the motorcycle
Important Installation Conside rations
In order to get more than about 3 inches of rise, some windshield and fairing
trimming may be required
Special Kit Requirements/Installation Tips
1. Contact - Slight fairing contact is ok as long as the steering stops can be
reached with out damaging the fairing
2. Fairing spacer pack recommended to lift the fairing for more rise.
Restrictions
1. Upper fairing and or windshield can be trimmed for more rise.
Line Routing
1. Electrical Lines to be freed from their brackets and or Zip Ties, and run on the
rider's side of the forks
2. Choke/Throttle advance line - Route behind the left fork tube
Recommended Riser Trim Length
1. 6.5" Riser Length = Trim Number 11
Recommended parts and replacement lines
1. Suzuki GSX-R1000 (01-04) Stock+50mm length Clutch Line. Part Number- 07-
0793. Order from ConvertiBARS
2. Suzuki GSX-R1000 (01-04) Stock+75mm length Throttle Lines. Part Numbers X621, X-622. Order from ConvertiBARS
3. Hydraulic Brake Line Top Fitting - 90 degree face to the side
4. Hydraulic Brake Line = Stock + 4"
Loading...