ConvertiBARS GSX600F User Manual

Suzuki GSX600F Katana 600(88-97)

Bike Specific Install Notes and Tips

This is an aftermarket product that fits up different than the stock components, therefore, the installer may be required to

set up com ponents and to route lines in the ?best way pos s ible?, which may not always be listed on this ?Bike

Specific? ins tallation sheet. In any case, the installation mus t allow the handlebars to reach both steering stops , with

out pulling taught or kinking any lines , and without damaging any part of the motorcycle

Important Installation Considerations

Some models may require raising the fork tubes slightly for full clamping.

Special Kit Re quirements/Installation Tips

1. Contact - Slight fairing contact is ok as long as the steering stops can be
reached with out damaging the fairing

2. Zip ties or brackets holding excess electrical lines will need to be cut or removed
to free up extra length.

3. Cyclops Clamps - are to be mounted on top of the triple clamp

4. Moving - Moving the clutch lever, and brake lever toward the center of the
motorcycle will allow greater upper fairing/windshield clearance

5. Fork Tubes - may need to be raised to mount ConvertiBARS Cyclops Clamps
on top of the triple clamp.

Restrictions

1. Fairing side pieces or intake ducts interfere with the riser when rotating the
Cyclops Clamps. Raising the handlebar so the riser is above the fairing side
pieces before rotating the Cyclops clamps will solve this restriction. Trimming
the fairing side pieces could also increase convertibility.

Line Routing

1. Throttle Lines - Take special care when routing to avoid interference with riser
pipe

2. Throttle Lines - Stock length - route behind the right fork tube

3. Electrical Lines to be freed from their brackets and or Zip Ties, and run on the
rider's side of the forks

Recommende d Rise r Trim Length

1. 5.0" Riser Length = Trim Number 8

Recommende d parts and re placement lines

1. Suzuki Katana 600(88-97) Stock+100mm length Clutch Line. Part Number 07-

0794. Order from ConvertiBARS.

2. Hydraulic Brake Line Top Fitting - 90 degree face to the side

3. Hydraulic Brake Line = Stock + 5"

4. Cable Clutch Line - Stock + 2"