ConvertiBARS Futura User Manual

Aprilia Futura

Bike Specific Install Notes and Tips

This is an aftermarket product that fits up different than the stock components, therefore, the ins taller m ay be required to

set up components and to route lines in the ?bes t way pos sible?, which may not always be listed on this ?Bike

Specific? ins tallation sheet. In any cas e, the installation mus t allow the handlebars to reach both steering stops , with

out pulling taught or kinking any lines, and without dam aging any part of the motorcycle

Important Installation Conside rations

Works well as a riser, however, fairing and triple clamp pinch bolts restrict

convertibility. Hydraulic lines top fittings need approx 30 degree bend. Riser
pipe will need to be trimmed to desired rise. some models will require raising
fork tube up approximatley 10-15mm.

Special Kit Re quirements/Installation Tips

1. Cyclops Clamps - are to be mounted on top of the triple clamp

Restrictions

1. Foreword Positions restricted by instrument panel

2. Kit works well as a riser, but there are restrictions when converting to a lower
handlebar position.

Recommended Riser Trim Length

1. 8.0" Riser Length = No Trimming

Recommended parts and re placement lines

1. Hydraulic Brake Line = Stock + 3"

2. Hydraulic Clutch Line = Stock + 2"