Honda CBR-1000RR(08+)
Bike Specific Install Notes and Tips
This is an aftermarket product that fits up different than the stock components, therefore, the ins taller may be required to
set up components and to route lines in the ?best way pos s ible?, which may not always be lis ted on this ?Bike
Specific? ins tallation sheet. In any case, the ins tallation must allow the handlebars to reach both steering stops, with
out pulling taught or kinking any lines, and without dam aging any part of the motorcycle
Important Installation Considerations
Confirmed, but the install sheet is not yet complete. Some customer feedback
suggests that longer clutch and throttle lines may be required. Contact us for
further information.
Special Kit Re quirements/Installation Tips
1. A thin Metal ring on each fork tube needs to be removed to allow the Cyclops
clamp to slide further down the fork leg. These rings are located on the fork
tubes, just under the stock handlebar.
2. Contact - Slight fairing contact is ok as long as the steering stops can be
reached with out damaging the fairing
3. Moving - Moving the clutch lever, and brake lever toward the center of the
motorcycle will allow greater upper fairing/windshield clearance
4. ConvertiABRS Reservoir mount(s) needs to be bent 90 degrees.
Line Routing
1. Throttle Lines - Longer than stock - route below brake lever
2. Clutch Line - Longer than stock - route as stock
Recommended parts and re place ment lines
1. Throttle Lines - Stock + 2"
2. Cable Clutch Line - Stock + 2"
Loading...