Converters.TV 963 Operation Manual

23 Inch LCD WVA VGA LCD

- ID#963

Operation Manual

Introduction

Features

Power Saver

This monitor is an open frame LCD Panel monitor. It features the VESA
plug & play system which allows the monitor to automatically adjust itself
to match the frequency of the user's device.

• High brightness.

• Fast response time.

• Power saver.

• Low electromagnetic wave and power saver.

• Safety certifications.

• The power control system is installed inside the LCD monitor.

• If the monitor has not been used for a certain period of time, the

system will turn the monitor to low voltage mode to save power. Any
button press will return the monitor to original state.

• Your input device e.g. your computer controls the power saver mode.

You can adjust these settings via your computer

• The LCD monitor is compatible with EPA Energy Star and N Tek if

used with a VESA DPMS computer.

• To save power, turn off the power of the LCD monitor when it is not

in use.

Plug and Play

• The VESA plug and play function eliminates the complicated and

time-consuming installation process.

• As this is a plug and play monitor. Your computer system can easily

identify and automatically adjust the monitor.

• The LCD monitor uses Display Data Channel (DDC) to send Extended

Display Identification Data (EDID) to the computer system, so the
computer system can be set to monitor auto adjust.

Setting up your

LCD monitor

Screen
Adjustment

• Choose a position where the reflection of the light is minimal and

away from a window for maximizing the quality of the screen image.

• It is important to keep 30cm between the LCD monitor to minimize

eye strain.

• Position the LCD monitor slightly above your horizontal vision as you

are sitting.

• Tilt either forward or backward for the most comfortable angle to view

the monitor. This LCD monitor supports connection to a computer or a
work station.

To enter adjust mode, please refer to the OSD control.

• Turn the computer and LCD monitor on.

• Press “Auto” button to start auto adjust.

• This will start the auto adjust process. This will take approximately 10

seconds. You may notice the image changing and occasionally
flashing (this is normal).

• Your LCD monitor provides a self testing function, through which you

can check whether the LCD monitor functions are working properly.

• If your LCD monitor is properly connected, but there is no image

showing and the indicator lights up in orange, please follow the below
steps:

• Shutdown the computer and the LCD monitor.

• Unplug the signal connector from the back of the computer.

• Turn the LCD monitor on.

• If the image connector is disconnected or damaged, a “No signal” sign

will pop up on the monitor.

• Turn off the LCD monitor and reconnect the signal cable, and then

turn the computer and LCD monitor on.

• If the LED of the LCD monitor is an orange colour after completing

the steps above, please check your VGA card and computer system.
Your monitor should be operating properly.