Converters.TV 901 Operation Manual

3G-SDI to HDMI Scaler with

Audio (L/R + SPDIF) - ID# 901

Operation Manual

Introduction

Features

The SDI to HDMI Scaler with Audio allows SD, HD and 3G-SDI signals to be
display on HDMI/SDI displays while ensuring high bit rates of 2.970 Gbps
gives you fast signal transmission without signal loss. For professional this
means that it is now easier to distribute and extend your SDI signal while
giving you the ability to display your work on the existing HDMI displays.
Further, the design of coaxial and L/R audio output allows user to output
audio with both digital and analog format and the loop-through 3G-SDI
design also benefit user to enjoy both SDI and PC/HD display
synchronously.

• Operation at 2.970Gbps, 2.970/1.001Gbps, 1.485Gbps,

1.485/1.001Gbps and 270Mbps

• Supports SMPTE 425M (Level A and Level B), SMPTE 424M, SMPTE 292M,

SMPTE 259M-C

• Equalized and re-clocked loop output

• Alternative audio output to coaxial and analog 2CH

Applications

• Integrated audio de-embedded for max 8 channels of 48k audio

• Auto video mode detection (3G/HD/SD)

• Conversion from SMPTE 425M level B to Level A for 1080p 50/59.94/60 4:2:2

10-bit

• Broadcast video signal sending to HDMI/SDI display

• Broadcast video signal extension

• 3G SDI signal convert into HDMI signal

Operation Controls
and Functions

Front Panel

① POWER LED: This blue LED will illuminate when the device is connected

with power supply.

② 3G LED: This green LED illuminate when the input SDI signal is with 3G format.
③ HD LED: This green LED illuminate when the input SDI signal is with HD format.
④ SD LED: This green LED illuminate when the input SDI signal is with SD format.
⑤ MENU: Press this button to enter/exit the OSD menu.

⑥ ENTER: Press this button to confirm your selection. Press both ENTER and –

buttons together to switch output timing to 720p instantly and press with +
buttons together to switch output timing to XGA.

⑦ -/+: Press these buttons to move up or down the OSD selections.

Back Panel

① SDI IN: This slot is where you connect the SDI source output for SDI signal

sending to be display on screen.

② SDI OUT: This slot is where you connect the SDI display with SDI cable for

input source display.

③ AUDIO OUT COAXIAL: This slot is where you connect the amplifier with

coaxial cable and from amplifier to speaker

④ AUDIO OUT R/L: These slots are where you connect the speaker or amplifier

with RCA jack for audio signal display.

HDMI⑤ OUT: This slot is where you connect the HDMI/DVI display with HDMI

and or HDMI to DVI cable

⑥ DC 5V: Plug the 5V DC power supply into the unit and connect the adaptor

to AC wall outlet. Blue LED will illuminate when the power is ON.