Converters.TV 15338 Operation Manual

HDMI 4K2K 1x2 SD-HD Scaler

- ID# 15338

Operation Manual

Introduction

Features

Applications

The 1 by 2 HDMI Scaler is designed to scale both 4K2K and non-4K2K
HDMI signal into 1080p and also, bypass 4K2K signal out on to 4K2K
display. Allowing all types of HDMI source signal to be display on HDTV/

Monitor. With friendly and simple design which allows user with direct
viewing on input resolution and output signal up to 2 simultaneous HDMI.
The 1 by 2 HDMI Scaler is your best media between HD and Ultra HD
signal.

• Supports HDMI 4K2K signal bypass

• Supports HDMI signal bypass

• Simultaneous HDMI outputs

• Friendly and simple to use

• Ultra HDMI source displaying on standard LED TV/monitor

• Ultra HDMI source displaying on 4K2K TV/Panel

• Examining if display supports 4K2K

• Examining if source supports 4K2K

System
Requirements

Input source equipment such as DVD/Blu-ray(4K2K) player and output
HDMI (4K2K) TV/display

Operation Controls
and Functions

Front Panel

1. HDMI OUT/SCALER: This slot is to connect with HDMI TV/display
for output AV displaying with resolution up to 1080p.

2. BYPASS: This slot is to connect with HDMI TV/display with or
without 4K2K specification for output AV displaying according to
inputsource signal setting.

Input Source Scaler Output Bypass Output

1080p 1080P 1080P
4K2K 1080P 4K2K

Note: Displaying HDMI 4Kx2K contents, equivalent source signal and
HDMI cable are required on BYPASS output connection.

3. HDMI IN: Connect from HDMI source equipment such as Blu-ray/DVD
player with or without 4K2K signal.

4. SERVICE 2: This slot is reserved for factory use only.

5. 4K2K / 1080P LED: These LED will illuminate according to input source

signal’s resolution when both LED are illuminating it state the input source’s
signal does not belong to 4K2K/1080P@24.

6. DC 5V IN: Connect 5V DC power supply into the unit and connect the
adaptor to an AC outlet.

Back Panel

1. RS-232: This slot is reserve for factory use only.

2. SERVICE 1: This slot is reserve for factory use only.

3. POWER LED: This LED will illuminate when the device is connected

with power supply.

4. BYPASS 4K2K: This LED will illuminate when the input signal contains
with 4K2K resolution.

5. MENU: Press this button to enter into OSD menu.

6. -/+: Press this button to scroll down/up the menu selection. Press “-“ with

“ENTER” button to switch SCALER output resolution to 720p instantly
or press “+” with “ENTER” button to switch SCALER output resolution
to XGA instantly.

7. ENTER: Press this button to enter or confirm the selection.