Converters.TV 15125 Operation Manual

DBaseT-Lite HDMI over CAT5e/6/7

with PoE Transmitter - ID# 15125

Operation Manual

Introduction

Features

HDBaseT-Lite HDMI over CAT5e/6/7 with PoE Transmitter can send

uncompressed video and audio over a single run of CAT5e/6/7 cable up to
60 meters (1080p) or 35 meters (4K×2K) with the added benefit of control
through the built-in RS-232 and 2-way IR ports. The Power over Ethernet

(PoE) function provides greater flexibility in installations.

• HDMI including 3D, 4k×2k supports, HDCP and DVI compliant

• Supports HDCP repeater and CEC bypass functions

• Supports HDBaseT Technology (Lite version) including 2-Way IR,

RS-232 and Power over Ethernet (PoE)

• Supports HD resolutions up to 1080p@60Hz/36-bit and Ultra HD

(4K×2K)

• Supports transmission distance of up to 60 meters through

CAT5e/6/7 cable (1080p) or 35 meters (4K×2K)

• Supports HDMI input up to 15 meters at 8-bit resolution or 10

meters at 12-bit resolution and output up to 15 meters at 8-bit
resolution and 10 meters at 12-bit resolution

• RS-232 with baud rate up to 115200/sec

• Supports wide range of IR frequency from 30 to 50 kHz

• Audio support up to LPCM 7.1CH, Dolby TrueHD, Dolby Digital

Plus and DTS-HD Master Audio

Applications

System Requirements

• Household entertainment sharing and control

• Lecture room display and control

• Showroom display and control

• Meeting room presentation and control

• Classroom display and control

Input HDMI source equipment such as DVD/Blu-ray players and HDMI
equipped output display (TVs or monitors).

Operation Controls
and Functions

Transmitter Front and Rear Panel

1. RS-232 In: Connect to a PC/laptop or RS-232 enabled device(with supplied

3.5 mm phone jack to D-Sub 9 pin adaptor) for the transmission of RS-232
commands.

2. IR2 Extender: Connect to the supplied IR extender cable for IR signal
reception. Ensure that remote controller being used is within the direct line-of­sight of the IR extender.

3. IR1 Blaster: Connect to the supplied IR blaster cable for IR signal
transmission. Place the IR blaster in direct line-of-sight of the equipment to be
controlled.

4. HDMI In: Connect to HDMI source equipment such as a DVD or Blu-ray
player.

5. DC 24V: Plug the 5 V DC power supply into the unit and connect the
adaptor to an AC outlet.

6. Link: The yellow LED will illuminate when both the input and output
CAT5e/6 signals are connected.

7. Power: This green LED will illuminate when the device is connected to a
power supply.

8. CAT5e/6 Out: Connect to the receiver unit with a single CAT5e/6 cable for
transmission of all data signals..