Converters.TV 15001 Operation Manual

15 inch SVGA

LCD Monitor ID#15001

Operation Manual

Introduction

Features

Power Saver

This is a 15 inch LCD SVGA input monitor for arcade machines and CNC
machinery retrofits. It features the VESA plug & play system which
allows the monitor to automatically adjust itself to the match the
frequency of the user's device.

• High brightness.

• Fast response time.

• Power saver.

• Low electromagnetic wave and power saver.

• Safety certifications.

• The power control system is installed inside the LCD monitor.

• If the monitor has not been used for a certain period of time, the

system will turn the monitor to low voltage mode to save power. Any
button press will return the monitor to original state.

• Your input device e.g. your computer controls the power saver mode.

You can adjust these settings via your computer

• The LCD monitor is compatible with EPA Energy Star and N Tek if

used with a VESA DPMS computer.

• To save power, turn off the power of the LCD monitor when it is not

in use.

Plug and Play

• The VESA plug and play function eliminates the complicated and

time-consuming installation process.

• As this is a plug and play monitor. Your computer system can easily

identify and automatically adjust the monitor.

• The LCD monitor uses Display Data Channel (DDC) to send Extended

Display Identification Data (EDID) to the computer system, so the
computer system can be set to monitor auto adjust.

Setting up your
LCD monitor

Screen Adjustment

To enter adjust mode, please refer to the OSD control.

• Turn the computer and LCD monitor on.

• Press “Auto” button to start auto adjust.

• This will start the auto adjust process. This will take approximately 10

seconds. You may notice the image changing and occasionally
flashing (this is normal).

• Your LCD monitor provides a self testing function, through which you

can check whether the LCD monitor functions are working properly.

• If your LCD monitor is properly connected, but there is no image

showing and the indicator lights up in orange, please follow the below
steps:

• Shutdown the computer and the LCD monitor.

• Unplug the signal connector from the back of the computer.

• Turn the LCD monitor on.

• If the image connector is disconnected or damaged, a “No signal

input” sign will pop up on the monitor.

• Turn off the LCD monitor and reconnect the signal cable, and then

turn the computer and LCD monitor on.

• If the LED of the LCD monitor is an orange colour after completing

the steps above, please check your VGA card and computer system.
Your monitor should be operating properly.

• If the “out of range” error pops up on the monitor, the input frequency

is outside of the specified range and will not display an image. The
correct frequency will need to be entered and then restart the monitor.

Panel Controls

1. LED Green : Power On + Signal Source

Detected

Red : Standby or Signal Source Not

Detected
Off : Power off

2. Power Power On/Off.

3. Up/+ This button is used for positive

adjustment when OSD is Displayed

4. Down/- This button is used for negative
adjustment when OSD is Displayed

5. Menu This button is used to display the ON
Screen Display (OSD) menu and select
settings and parameters.

6. Auto Automatically optimize positions, phase
and clock when OSD is not shown.

Adjusting the