Conversor Listenor PRO User Manual
Table of Contents
Welcome! 3
Listenor Pro overview 4
Safety Information 5
Getting started 6
Everyday use 7
Using with earphones or headphones 8
Using with an inductive loop 8
Attaching the belt clip 9
Sockets and connections 10
Using the neck lanyard 12
Care instructions 13
Repair and service centres 13
Troubleshooting 14
Manufacturer’s warranty 15
Statements of compliance and conformity 17
© Copyright 2013 Conversor Limited. All rights reserve
Welcome!
Thank you for your purchase of Listenor Pro, a
versatile high quality Assistive Listening Device
which enhances the clarity of sound in a variety of
everyday situations made by Conversor Limited.
Listenor Pro is not sold, advertised, or intended for
use as a personal hearing aid. Conversor
recommends that any individual experiencing
hearing loss be examined by a physician to
determine the cause before using amplification.
Listenor Pro includes the following:
• Listenor Pro
• 2 AAA Batteries
• Detachable Belt Clip
• Earphones or headphones
Optional accessories not included (with order code)
• PROV1LTK - Telephone Connector
• CON01MM1 - Directional microphone
• PROV1LAU - Audio Jack Cable
• PROV1LTV - TV Cable
• SUB01IND - Inductive Neck Loop
• CON01HDP – Headphones
• CON01EAR – Earphones
• PROV1CPR – Conversor Pro Recorder
To order any of the optional accessories locate
your local dealer on the Conversor website
www.conversorproducts.com, purchase from
the Conversor website shop, or contact
Conversor at info@conversorproducts.com using
the order codes above.
3
Listenor Pro overview
Socket for
earphones,
headphones or
inductive loop
Microphone
Socket for
audio cable
and
directional
microphone
Belt clip
locating tongue
Belt clip grooves. Align and
locate belt clip in grooves
and slid under tongue until
locked in
place
Volume control
but tons
ON/OFF button
in the centre
Top view
Underside View
Tone control
buttons
Neck Lanyard hook
Belt/lapel
clip
Battery Cover
Press ridges
and slide open
4
Safety information
CAUTION! Hearing Safety
This product is designed to amplify sounds to a
high volume level which could potentially cause
hearing damage if used improperly. To protect
your hearing and the hearing of others:
• Make sure the volume is turned down
before putting on the earphone or
headphone before adjusting the volume
to a comfortable level.
• Set the volume level at the minimum
setting that you need to hear.
• If you experience feedback (a squealing or
howling sound), reduce the volume setting
and move the microphone away from the
earphone or headphone.
• Do not allow children or other unauthorised
persons to have access to this product.
CAUTION! Battery Safety and Disposal
This product is supplied with non-rechargeable
Alkaline batteries. Do not attempt to recharge
single-use batteries, which may explode, release
dangerous chemicals, cause burns, or other
serious harm to the user or product.
CAUTION! Pacemaker Safety
• Before using this product with a pacemaker
or other medical device, consult your
physician or the manufacturer of your
pacemaker or other medical device.
• If you have a pacemaker or other medical
device, make sure that you are using this
product in accordance with safety
guidelines established by your physician
or the pacemaker manufacturer.
5
Getting started
1. Listenor Pro uses two AAA disposable batteries.
2. Open the battery compartment using your thumb
to apply pressure to the ribs on the battery door
and slide it down and away from the Listenor Pro.
3. Insert two disposable AAA batteries into the
battery compartment being careful to place
them with the correct orientation of positive(+)
and negative(-) terminals.
4. Close the battery compartment door by
aligning it on the back of the unit and slide it
upwards until it snaps into place.
5. Insert the belt clip on the rear of the Listenor
Pro as directed on page 9.
6. Plug the earphones or headphones into the
socket marked with the headphone icon.
The Listenor Pro can be used with optional
Inductive Neck Loop, headphones or earphones.
7. Switch on the Listenor Pro by pressing the
central button in the middle and holding down
for two seconds. The light in the centre will
flash green indicating that the Listenor Pro is
on. When the battery is low the light in the
centre will flash red.
8. Adjust the volume up or down by pressing the
central button at the top-for volume up-or at the
bottom-for volume down. A light will indicate the
volume level, with a full line indicating maximum
volume. There are 16 volume positions. A single
beep sound is heard when you change the
volume setting. A double beep is heard when the
highest or lowest volume setting is reached.
6
Loading...