Control Products A510SS User Manual

RUSSELL PUMP

Model A510SS

End Suction, Close Coupled, All Stainless

Centrifugal Pump

Typical Applications Include:

General Purpose, OEM, Boosters

Cooling Towers, Boiler Feed,

Process Fluids, HVAC, Irrigation,

Hot and Chilled Water Circulation

Russell Pump and Engineering Inc.

102 W. Chicago Street

Albion, IA 50005

641-488-2319

Design Features

Casing Constructed of cast 304 stainless steel. the discharge can be mounted in any

90˚ position. Drain and air ports are also positioned every 90˚, 1/4 npt suction

and discharge tappings are standard. Back pull out design allows the pump to

be serviced without disturbing the piping. The volute was designed to maxi­mize hydraulic efciency.

Mechanical Seal Type 21 buna-n seal is rated 225˚F and pressures to 175PSI. Carbon seal face

mates with the ceramic seat providing years of trouble free service. Alternate
seals available upon request.

Impeller The hydraulic design of the impeller maximizes pressure and gpm while mini-

mizing horsepower. The enclosed impeller is made of cast 304 stainless steel.

Adapter The precise machining of the adapter allows for easy assembly of the pump. a

1/8 npt hole is provided if a seal ush line is added. Construction consists of

cast 304 stainless steel.

Motor The NEMA 56J motor utilizes a 416 stainless steel shaft. The motor’s heavy

duty ball bearings withstand axial and radial thrust loads with no problem.
Standard enclosure type is drip-proof but alternates are available.

Limitations

Maximum Working Pressure 175PSI

Maximum Gallons Per Minute 82

Maximum Head Produced 105 ft.

RPM 3450

Maximum Seal Temp Buna-N 225˚F

EPT 300˚F

Viton 400˚F

Maximum Horsepower 2

Specications

The contractor shall furnish (and install as shown on the plans) a Russell Series A510SS close coupled,
centrifugal, all stainless pump. Each 1” x 1 1/4” pump shall have a the capacity of ____ GPM when
operated at a total of ______ feet.

The pump casing shall be radially split, end suction with 1/4 npt suction and discharge gauge tappings
included. The casing should be able to accomodate any 90˚ mounting position. There shall be four
drain/air ports drilled and tapped 90˚ apart. The casing design should be of a back pull out type.

The pump is to be furnished with a mechanical seal which incorporates stainless steel parts. Buna-N

elastomers, ceramic seat, and carbon seal face shall be standard.

The adapter shall be drilled and tapped to allow for the possible addition of a steal ush line.

The pump shall be close coupled to a NEMA C face _____HP _____Phase _____Hertz _____Voltage
_____RPM drip-proof motor. The motor shall be sized to prevent overloading at the duty point. The
motor shall have a stainless steel shaft and sealed bearings.

Each unit shall be checked by the contractor to regulate the correct pressure, voltage, and amp draw.