Controlled Entry Distributors FFIII318LI1 Users Manual

Community Controls Firefly3TM Type: FIRlll318LIPW2K

FCC ID: SU7FF

III318LI1

318 2 Btn FixedCode

3

Any changes or modifications to Community Controls equipment not
expressly approved by Community Controls could void the manufacturer’s
warranty and could void the user’s authority to operate the equipment.

The warranty period of Community Controls Firefly3™ transmitters is
twenty-four (24) months. This warranty shall begin on the date the
transmitter is manufactured. During the warranty period, the product will be
repaired or replaced (at the sole discretion of Community Controls) if the
product does not operate correctly due to a defective component. This
warranty does not extend to (a) the transmitter case, which can be damaged
by conditions outside the control of Community Controls, or (b) battery life
of the transmitter. This warranty is further limited by the following disclaimer
of warranty and liability:

EXCEPT AS SET FORTH ABOVE, COMMUNITY CONTROLS MAKES NO WARRANTIES REGARDING THE
GOODS, EXPRESS OR IMPLIED, INCLUDING WARRANTY OF MERCHANTABILITY OR WARRANTY OF FITNESS
FOR A PARTICULAR PURPOSE. BUYER MAKES NO RELIANCE ON ANY REPRESENTATION OF COMMUNITY
CONTROLS, EXPRESS OR IMPLIED, WITH REGARD TO THE GOODS AND ACCEPTS THEM “AS-IS/WHERE-IS”.
COMMUNITY CONTROLS SELLS THE GOODS TO BUYER ON CONDITION THAT COMMUNITY CONTROLS
WILL HAVE NO LIABILITY OF ANY KIND AS A RESULT OF THE SALE. BUYER AGREES THAT COMMUNITY
CONTROLS SHALL HAVE NO LIABILITY FOR DAMAGES OF ANY KIND, WHETHER DIRECT, INCIDENTAL OR
CONSEQUENTIAL DAMAGES, INCLUDING INJURIES TO PERSONS OR PROPERTY, TO BUYER, ITS
EMPLOYEES OR AGENTS, AS A RESULT OF THE SALE. BUYER ALSO AGREES TO HOLD COMMUNITY
CONTROLS HARMLESS FROM ANY CLAIMS BUYER, OR ANY THIRD PARTY, MAY HAVE AS A RESULT OF
BUYER’S USE OR DISPOSAL OF THE GOODS. BUYER HAS READ THIS DISCLAIMER AND AGREES WITH ITS
TERMS IN CONSIDERATION OF RECEIVING THE GOODS.

NOTICE

2500 South 3850 West, Suite A

Salt Lake City, UT 84120

[phone] Fax

www.communitycontrols.com

[phone]

Made in Taiwan. Copywrite © 2015 Community Controls.

1 - TRANSMITTER OVERVIEW

2 - NUMBERING
3 - PROGRAMMING
4 - OPERATION
5 - BATTERY ACCESS
6 - TROUBLESHOOTING

Linear’s MegaCode® series of digital transmitters are wireless radio controls
designed for use with MegaCode format receivers. The MegaCode radio
format provides unparalleled security. Each transmitter is pre-set at the factory
to one of over 1,000,000 codes. The 318FixedCode is a two-button
transmitter that sends a unique code to a single device. The transmitter is
powered by one Type "23A 12V" batteries.

2 - NUMBERING

Each transmitter is manufactured and sold with a different factory- set serial number.

3 - PROGRAMMING

The transmitter must be programmed into your system memory.
Your own installer or reseller will provide you the necessary instructions for your
system.

4 - OPERATION

A - Firmly depress the button until the small red LED illuminates.
B - After the LED has illuminated, release the button.
If the device you are attempting to activate does not respond, repeat steps A and
B or consult section 7 ( Troubleshooting ) of this manual.

5 - BATTERY ACCESS

To access the battery, remove the set screw. Next, place a flat object such as
a coin in the top corner notch of the case. Twist the object gently to open the
case. Attend to proper polarity when installing or replacing the battery. When
complete, squeeze the top and back cover gently together until the case is
completely closed, then replace and tighten the screw.

NOTE: Please dispose of the batteries properly according to local laws

regulations. Test proper battery installation by verifying that the LED

and
illuminates when the button is pushed.

6 - TROUBLESHOOTING

Fault

The system does not receive the transmitter signal
The transmitter led is OFF

The transmitter led is blinking
The operating range is reduced

The system does not receive the transmitter signal
The transmitter led is ON .

Solution

Replace the transmitter

battery

Check the power supply

of the receiver

Operating frequency : 318MHz
Number of buttons : 2
Battery : 1 ea. 12V A23
Operating temperature : -20°F - 85°F
Overall dimensions : 2-1/8 x 1-9/16 x 1/2 inch
Weight: 1 oz.

Push
Buttons

Black Case with Blue Buttons

Case
Notch

Screw