Controlled Entry Distributors 418ELPW1K Users Manual

ELPRO INNOTEK S.p.A.

TCF-107

MONARCH ONE BUTTON - Type:

Transmitter

Solutions

Thank you for choosing a Transmitter Solutions product .

Please read this manual carefully before using the p roduct.

Made in Italy. Copyright

1 - TRANSMITTER OVERVIEW

1A - General information
1B - Technical specifications
1C - Main components

2 - NUMBERING

3 - PROGRAMMING

4 - OPERATION

5 - BATTERY ACCESS

6 - TROUBLESHOOTING

© 2006 by Transmitter Solutions

CONTENTS

Annex 8 : User manual

The Transmitter Solutions - 418R receiver which operates with this
transmitter has a Wiegand 26 bit output and can operate any type of
access control system equipped with the same protocol. The CR 2016
lithium batteries of the transmitter have a shelf life of about 6 months.

European Directives 99/5/CE, 89/336/CEE, 73/23/CEE.

1B - Technical specifications

Operating frequency 418 MHz

Number of keys: 1

Battery : 2 x 3V lithium batteries CR2016

Battery life: 18 24 months

Number combinations : 65,536

Protocol : Elite compatible

Different Facilities codes 256

Operating temperature: -20°F÷+131°F (-20°C÷+55°C)

Overall dimensions: 2.4”x1.4”x0.51” (61x36x13 mm)

Weight: 0.49 oz. (14 gr.)

1C - Main compon ents

Red
LED

418ELPW1K

Part 15 of FCC Regula tions and The product fully co mplies with the

÷

Green

push-button

1A - General information

The Transmitter Solutions - Monarch 418ELPW1K transmitter is a key
chain style mini transmitter operating at 418 MHz. It has been designed
for use w ith programmable tel ephone entry, security, and access contro l
systems operating with a 418 MHz frequency receiver. The code sent by
the transmitter includes a 16 bit security code which allows up to
65,536 code combinations and 8 bits of facility code which allows up to
256 facility codes .

2 - NUMBERING

Each transmitter is manufactured and sold with a differ ent factory-set serial
number .

3 - PROGRAMMING

The tra nsmitter m ust be progr ammed into your syste m memo ry.
Your own installer or reseller will provide you the necessary instructions for your
system.

4 - OPERATION

A - Firmly depress the button until the small red LED illuminates.
B - After the LED has illuminated , release the button.
If the device you are attempt ing to activate doe s not respond, r epeat steps A and B
or consult section 6 ( Troubleshooting ) of this manual.

5 - BATTERY ACCESS

To access the battery open t he case wi th a screwdriver acting on the slot betwe en
the cover and the bottom and remove the botto m, as show n in fig. 3a and 3 b.
Slide out the old batteries and replace them with the new ones ]
respectin g the po larity, wit h the positi ve (+) side upward.

NOTE: Please dispose of the batteries properly according to local laws and
regulations.
Test proper battery installation by verifying tha t the red LED illuminates when
the button is p ushed.

[CR2016

Fig. 3a

Dark grey

case

Key

ring

Fig. 2

holder

6 - TROUBLESHOOTING

PROBLEM

The syst em does not re ceiver th e

transmitter signal.

The transmitter LED will not light

The syst em does not re ceiver th e

transmitter signal.

The tr ansmitt er LED is ON

The opera ting rang e is reduc ed

Transmitter Solutions - Type : 418ELPW1K

FCC ID : SU7418ELPW1K

This device complies with FCC Rules
Operati on is subje ct to the f ollowing two condition s:
(1) This device may not cause harmful interference, and
(2) this device must accept interference received, including
interfere nce that may caus e undesired oper ation.

Any changes or modification to equipment not expressly
approved by could void the manufacturer’s warranty.

Transmitter So lutions

Notice

Transmitter Solutions

WARRANTY

The warranty period of 418 transmitters is 24 months ,
beginning f rom the manu facturing date of the trans mitter. During th is period, if th e
product does operate correctly, due to a defective component, the product will be
repaired o r replaced at t he sole discreti on of .
The warranty does not extend to the transm itter case which can be dam aged by
conditions outside the control of or to battery life.

Transm itter Solutions

Tra ns m itt er S ol ut io ns

SOLUTION

Replace the transmitter

batte ries

Check to verify the

transmitter is programmed

into your system

Replace the transmitter

batte ries

Part . 1 5 o f th e

Tra ns m itt er S ol ut io ns

Fig. 3b

TRANSMITTER SO LUTIONS

2505 Chandler Avenue, Suite, 1

Las Vegas, NV 89120 -

(866) 975- 0101 - (866) 975-04 04 Fax

sales@transmittersolutio ns.com

IS-TM141CCUK Rev. 1 del 19.05.2006

Annex 8 = User manual Pag 1 of 1