Control Company ROBO THERMOMETER User Manual

TRACEABLE® ROBO™ THERMOMETER INSTRUCTIONS

SPECIFICATIONS:

Display: ¼” LCD
Range: –58.0 to 536.0 °F

–50.0 to 280.0 °C

Resolution: 0.1° above –20.0° and below 200.0°

1.0° below –20.0° and above 200.0°
Accuracy: Cat. No. 4149
±1°C –20 to 100 °C
Cat. No. 4349
±0.4°C –20.0 to 100.0 °C at

tested points

Sampling
Rate: 1 second

Features: Protective sleeve with pocket clip,

8” stainless steel probe, 180 de­gree rotating digital display, extra­wide temperature range.

CONTROLS/INDICATORS

°F/°C button and ON/OFF button.

ULTRA™ THERMOMETER ACCURACY

Ultra™ thermometers are tested at selected test
points to be within tighter than normal toler­ances to assist in providing improved accuracy.
Other points will not necessarily fall within the
same accuracy as those found at the selected
test points, but will be within an accuracy of ±1°
between –20.0 and 100.0°C.

OPERATION

1. Press the “ON/OFF” button to turn the thermom­eter on.

2. Press the “°F/°C” button to toggle between dis­playing the temperature in Fahrenheit and
in Celsius.

3. Remove the thermometer from the protective
plastic sleeve and insert the probe into the mate­rial to be measured.

4. The head of the thermometer rotates 180 degrees
in order to read the display at various angles.

5. Press the ON/OFF button to turn the unit off.

ALL OPERATIONAL DIFFICULTIES

If this unit does not function properly for any reason,
replace the battery with a new high-quality battery
(see “Battery Replacement” section). Low battery
power can occasionally cause any number of “ap­parent” operational difficulties. Replacing the battery
with a new fresh battery will solve most difficulties.

BATTERY REPLACEMENT

Erratic readings, a faint display, or no display are
all indicators that the battery must be replaced.
Remove the battery cap by turning ¼ turn counter
clockwise. Replace exhausted battery with a new

1.5 volt battery. Make certain that positive (+) side

is face up. Replace battery cap. Do not overtighten
the cap. Replacement battery Cat. No. 1039.

WARRANTY, SERVICE, OR RECALIBRATION

For warranty, service, or recalibration, contact:

CONTROL COMPANY

4455 Rex Road

Friendswood, Texas 77546 USA

Ph. 281-482-1714 Fax [phone]

E-mail [e-mail]

www.control3.com

Control Company is ISO 9001 Quality-Certified by DNV and

ISO 17025 accredited as a Calibration Laboratory by A2LA.

Cat. No. 4149/4349

®

Traceable

Traceable® is a registered trademark of Control Company ©

Robo™ Thermometer Instructions

92-4149-00

Rev. 3 083006

2006

CONTROL COMPANY