Control Company POCKET TIMER User Manual

TRACEABLE® POCKET TIMER INSTRUCTIONS

SPECIFICATIONS

Display: ¼”-high, 4-digit LCD
Range: 19 hours to 59 minutes
Resolution: 1 minute
Accuracy: ± 0.01%
Alarm: Audible
Size: 2 x 1⅛ x ⅜ inches
Weight: ½ ounce
Features: Keychain, Countdown/ Countup Timing

Controls:
H - Hour button.
M - Minute button.
S/S - Start/Stop button.

OPERATION
Clearing The Display:

To clear the display to 0:00
press the H and M buttons
simultaneously. The unit will
beep 2 (two) times when the
display is cleared.

Countdown Timer/Alarm Operation

1. Clear the display to 0:00.

2. Press H button to set number of hours desired. Setting will advance 1
hour each time button is pressed. Press and hold to advance rapidly.

3. Press M to set number of minutes desired. Setting will advance 1 minute
each time button is pressed. Press and hold to advance rapidly.

4. Once desired time is displayed, press the S/S button to start the
countdown operation.

5. At zero the alarm will sound for 1 minute and stop automatically.

6. Pressing the H and M buttons simultaneously silences the alarm and
clears the display to zero.

Warranty, Service, or Recalibration

For warranty, service, or recalibration, contact:

CONTROL COMPANY

7. Press the S/S button to manually silence the alarm and to also begin
countdown timing again from the time set.

Note: The blinking “:” symbol in the display indicates timer is running.

Count-up/Stopwatch Operation

1. Clear the display to 0:00.

2. Press the S/S button to start count-up/stopwatch operation.

3. Press S/S button to stop count-up/stopwatch operation.

Note: When timing capacity reaches 19 min. and 59 sec. the timer
automatically rolls over to zero and continues timing.

Time Out

If a pause in countdown or count-up operation is required press the SS
button to “freeze” display at current reading (time-out). To re-start operation,
press S/S button again. An unlimited number of time-outs may be taken.

OPERATIONAL DIFFICULTIES

If this unit does not function properly for any reason, replace the battery with
a new high-quality battery (see “Battery Replacement” section). Low battery
power can occasionally cause any number of “apparent” operational
difficulties. Replacing the battery with a new fresh battery will solve most
difficulties.

BATTERY REPLACEMENT

Erratic readings, a faint display, no display, or a flashing display are all
indicators that the battery must be replaced. Slide battery cover off the
backside of unit in direction indicated by arrow. Replace exhausted battery
with a new 1.5-volt Battery with the positive side up. Replace battery cover.
Replacement battery Cat. No. 1104.

4455 Rex Road

Friendswood, Texas 77546 USA

Ph. 281-482-1714 Fax [phone]

E-mail [e-mail]

www.control3.com

Control Company is ISO 9001 Quality-Certified by DNV and ISO 17025 accredited as a Calibration

Laboratory by A2LA.

Rev. 1 120804

Control Company Cat. No. 1060
Traceable® is a registered trademark of Control Company

© 2008 Control Company