Control Company MONITORING THERMOMETER User Manual

TRACEABLE

MONI

TORI

THERMOMETER INSTRUC

ONS

SPECIFICATIONS Display: LCD ¾” Ranges: (ambient) 32.0 to 122.0°F (0.0 to 50.0°C)

(probe) –58.0 to 158.0°F (–50.0 to 70.0°C)

Resolution: 0.1°C Accuracy: ±1°C Sampling Time: approximately 10 seconds Power: 1-year AAA alkaline battery Size: 3¼ x 2¼ x ⅝ inches Accessories sensor bracket, Velcro™, stand, battery, Supplied: Traceable® certificate, instructions.

DESCRIPTION

1. Display

2. In/probe Switch

3. Vent holes

4. Hanger Slot

5. °C/°F Switch

6. Stand

7. Battery Door

8. Probe

Operation

1. Turn the thermometer on by inserting the battery. Too insert the battery, slide the Battery Door located on the back in the direction of the arrow (7, Fig. 1). Insert the battery as directed by the polarity symbols (+ and -). Replace the Battery Door.

2. Select probe or ambient temperature by switching to the desired position (2, Fig. 1).

3. Select Fahrenheit or Celsius by switching to the desired unit of measurement (5, Fig. 1).

4. Display will update every ten seconds.

5. To reset the unit, remove the battery for 4-5 seconds and then reinstall. For accurate measurement on ambient temperature, keep the unit where air can flow freely around it.

6. Flip out the plastic stand on the back of the unit to stand on a table. Mount to wall by sliding Hanger Slot (4, Fig. 1) onto a screw set in the wall (not flush).

Low Battery Display

Erratic readings, a faint display, or no display are all indicators that the battery is low and needs to be replaced. To replace the battery, slide the Battery Door located on the back in the direction of the arrow. Insert a new 1.5V AAA alkaline battery, NOT a regular or heavy duty battery, as directed by the polarity symbols (+ and –). Incorrectly installed batteries may damage electronics. Replace the Battery Door.

All Operational Difficulties

If this thermometer does not function properly for any reason, please properly replace the battery with a new 1.5V AAA alkaline battery (see Low Battery section, above). Low battery power can occasionally cause any number of “apparent” operational difficulties. Replacing the battery with a new fresh battery will solve most difficulties.

WARRANTY, SERVICE, OR RECALIBRATION

For warranty, service, or recalibration, contact:

CONTROL COMPANY

4455 Rex Road

Friendswood, Texas 77546 USA

Ph. 281-482-1714 Fax 281-482-9448

E-mail sales@control3.com

www.control3.com

Control Company is ISO 9001 Quality-

Certified by DNV and ISO 17025 accredited

as a Calibration Laboratory by A2LA.