Control Company LONG-STEM THERMOMETER User Manual

TRACEABLE® LONG-STEM THERMOMETER INSTRUCTIONS
SPECIFICATIONS: Model: 4052 4352 4353 4354 Range: –58 to 302°F –58 to 302°F –58 to 572°F –58 to 572°F
–50 to150°C –50 to 150°C –50 to 300°C –50 to 300°C
Accuracy: ±1°C ±0.2°C ±1°C ±0.5°C Length
Stem: 8” 8” 11.4” 11.4”
Overall: 11” 11” 14.4” 14.4” Diameter:
Stem: 1/8” 1/8” 1/8” 1/8”
Top: 1.2” 1.2” 1.2” 1.2”
Display: 3/8” LCD
Resolution: 0.1° above –20 and below 200
1.0° below –20 and above 200
Sampling Rate:
10 seconds in Fahrenheit mode
1 second in Celsius mode
Features: Stainless steel probe protective plastic sleeve
OPERATION
1. To turn the thermometer on slide the ON/OFF switch to the ON position.
2. To measure in Fahrenheit select the “F” position of the F/C switch or “C” to measure in Celsius.
3. Remove the protective plastic sleeve of the thermometer probe and insert the probe into the material to be measured.
4. To turn the thermometer off slide the ON/OFF switch to the OFF position. To conserve battery life, always turn the unit off when not in use.
CONTROL COMPANY
4455 Rex Road
Friendswood, Texas 77546 USA
Ph. 281-482-1714 Fax 281-482-9448
E-mail info@control3.com
www.control3.com
ALL OPERATIONAL DIFFICULTIES
If this unit does not function properly for any rea­son, replace the battery with a new high-quality battery (see “Battery Replacement” section). Low battery power can occasionally cause any number of “apparent” operational difficulties. Replacing the battery with a new fresh battery will solve most dif­ficulties.
BATTERY REPLACEMENT
Erratic readings, a faint display, or no display, are all indicators that the battery must be replaced. Remove the battery cap, located at the top of the unit by turning it in the direction of the arrow (counterclockwise). Remove the exhausted battery and replace with a new 1.5 volt battery. Replace the battery cover. Do not overtighten the cap. Replace­ment battery Cat. No. 1039.
WARRANTY, SERVICE, OR RECALIBRATION
For warranty, service, or recalibration, contact:
Control Company is ISO 9001 Quality-Certified by DNV and ISO 17025 accredited as a Calibration Laboratory by A2LA.
Cat. No. 4052 / 4352/ 4353 / 4354
92-4052-10
Rev. 3 040809
Traceable® is a registered trademark of Control Company
© 2009 Control Company
Loading...