Control Company FLEXIBLE-ARMTM LIGHT User Manual

FLEXIBLE-ARMTM LIGHT INSTRUCTIONS

SPECIFICATIONS:

Electrical: 150 VAC, 60Hz, UL Listed Light: 35 watt Halogen bulb Plug: Polarized Arm length: Cat. No. 3095 - 21”

Weight: 8 lbs.

FEATURES

• Base - 7” diameter, 7lb.

• 35 watt bright Halogen white light

• Clamping unit for vertical or horizontal Positioning

• Switch in cord

• Flexible-Arm ™ articulates at 3 points

• Fingertip bar for raising, lowering and pivoting with ease

• Spring counterbalance for stability

• Vented shade with rolled edges

• Safety-glass with UV filter

BASE ASSEMBLY (see Figure 1)

1. Remove “Screw I” from base “Stem II”.

2. Insert the lamp frame into base “Stem II”, align screw holes.

3. Screw in “Screw I” and finger tighten.

CLAMPING UNIT ASSEMBLY

1. Insert the lamp frame into hole in top of clamp assembly.

2. Loosen clamp with lever on bottom of assembly.

3. Position clamping mechanism and tighten firmly using lever on bottom of assembly.

BULB REPLACEMENT (see Figure 2)

1. Turn off lamp and allow shade and accessories to cool.

2. Turn the lampshade upward.

3. Remove CENTER screw (using a Phillips screwdriver) and clip from protective glass cover.

4. Pull out failed bulb and replace with halogen bulb. (Control Company Cat. No. 3098)

5. Replace protective glass and clip and screw in place.

NOTE: Do not remove screws holding fingertip bar in place.

WARRANTY, SERVICE, OR RECALIBRATION

For warranty, service, or recalibration, contact:

Cat No. 3096 - 31”

Figure 1.

CONTROL COMPANY

4455 Rex Road

Friendswood, Texas 77546 USA

Ph. 281-482-1714

Fax 281-482-9448

E-mail sales@control3.com

www.control3.com

Control Company is

ISO 9001 Quality-Certified by DNV and

ISO 17025 accredited as a

Calibration Laboratory by A2LA.

Cat. No. 3095/3096

Flexible-ArmTM Light Instructions

92-3095-10

Rev. 1 071504

Traceable® is a registered trademark of Control Company

Figure 2.