Control Company DISHWASHER THERMOMETER User Manual

SPECIFICATIONS
Range: –50 to 150 °C
Battery: 357A button cell

alkaline
or
357 silver-oxide (Cat No. 1039)

Features a convenient stand and hook that is specically

designed to be used in a dishwasher. Waterproof unit is
designed for rough handling.

OPERATION

Press the ON/OFF button once to turn on the unit. The
unit will turn on and begin reading temperature in Celsius.
To switch between Fahrenheit/Celsius, press the °C/°F
button. Insert unit into the desired location to begin
measuring temperature.

MAXIMUM/MINIMUM

To view the Maximum and Minimum temperature the
thermometer has achieved since the unit has been turned
on, press the MAX/MIN button to view the Minimum tem­perature. Press MAX/MIN button again within 3 seconds
to view the maximum temperature.

Note: Turning off the unit will reset the Maximum and

Minimum memory.

HOLD FUNCTION

To “freeze” a temperature displayed on the LCD, press
the HOLD button once to continuously show the current
temperature. “HOLD” will ash on the display to indicate
that you are currently using the HOLD function. To exit
HOLD, press the HOLD button, and the current tempera­ture will be displayed.

ALL OPERATIONAL DIFFICULTIES

If this thermometer does not function properly for any
reason, replace the battery with a new high-quality
battery (see “Battery Replacement” section). Low battery
power can occasionally cause any number of “apparent”
operational difculties. Replacing the battery with a new
fresh battery will solve most difculties.

BATTERY REPLACEMENT

Erratic readings, a faint display, no display, or low battery
icon are all indications that the battery must be
replaced. To replace the battery, with the unit facing

forward, unscrew the metal housing cover counterclock-

wise until the front half is removed. Carefully remove the
faceplate, and then gently pry the electronics component

out of its metal casing. With the unit removed from its
casing, turn it over to expose six screws. Using a Phillips®

#000 screwdriver or equivalent, remove the six screws,
gently remove the plastic casing, and then remove the
exposed battery. Replace the battery with a new 1.5 volt
357 silver oxide battery (Replacement Cat. No. 1039).
Make certain the positive (+) side is facing out. Replace

the plastic cap onto the unit and screw the six screws

back into the electronics component. Return component

to its metal casing, replace the faceplate, and screw on

the metal housing cover by turning it clockwise.

WARRANTY, SERVICE, OR CALIBRATION

For warranty, service, or calibration contact:

CONTROL COMPANY

4455 Rex Road

Friendswood, Texas 77546 USA

Ph. 281 482-1714 • Fax [phone]

www.control3.com • [e-mail]

Control Company is ISO 9001 Quality-Certied by DNV and

ISO 17025 accredited as a Calibration Laboratory by A2LA

Control Company Cat. No. 4203

Traceable® is a registered trademarks of Control Company.

2013 Control Company. 92-4203-00 Rev. 0 08202013

©

TRACEABLE

DISHWASHER

THERMOMETER

INSTRUCTIONS

®