Control Company BIG-DIGIT 4-ALERT THERMOMETER °C °F User Manual

OPERATING INSTRUCTIONS

Normal display shows inside and outside temp in 1/10 degree.

— Press “Hi Set” to set desired High Temp Alert. — Press “Alert On/Off” to turn on the High Temp Alert. (“Alert” flag appears on

display.)

— Alarms and LCD flashes 5 sec every one min when the sensed temp is higher

than the set temp.

b. Low Temp Alert “▼”

— Slide switch to temp “Alert” position, press “Alert Select” to select Low Temp Alert

“▼” mode.

FITTING THE OUTSIDE SENSOR: LOCATE OUTSIDE SENSOR AWAY FROM DIRECT SUNLIGHT AND HEAVY SATURATION.

— Press “Hi set” to set the desired upper temp alert value. — Press “Lo set” to set the desired lower temp alert value. — Press “Alert on/off” to turn, on the Inside Temp Alert. (“Alert” flag appears on

display).

— Alarms and LED flashes 5 sec every one mm when the sensed temp is within the

set temp.

— Press “Lo set” to set the desired lower temp alert value. — Press “Alert on/oft” to turn on the Outside Temp Alert. (“Alert” flag appears on

display)

— Alarms and LED flashes 5 sec every one mm when the sensed temp is outside the

set temp.

3. Slide switch to “Temp” position after setting temp alert.

4. Alert off Press “Alert on/off” in temp “Alert” position, “Alert” flag disappears on display.

TRACEABLE® BIG-DIGIT 4-ALERT THERMOMETER °C/°F INSTRUCTIONS

1. One point temp control

a. High Temp Alert “▲”

— Slide switch to temp “Alert” position, press “Alert Select” to select

High Temp Alert “▲” mode.

— Press “Lo set” to set desired Low Temp Alert. — Press “Alert On/Off” to turn on the Low Temp Alert. (Alert flag

appears on display.)

— Alarms and LCD flashes 5 sec every one mm when the

sensed temp is lower than the set temp.

2. Two point temp control a. Inside Temp Alert “ ”

— Slide switch to temp “Alert” position, press “Alert Select” to select

Inside Temp Alert “ ” mode.

b. Outside Temp Alert “ ”

— Slide switch to temp “Alert” position, press “Alert select” to

select Outside Temp Alert “ ” mode.

— Press “Hi set” to set the desired upper temp alert value.

EASY MOUNTING OF BRACKET ON WALL BY:

— Double-sided tape or — Screws

WARRANTY, SERVICE, OR RECALIBRATION

For warranty, service, or recalibration, contact:

Ph. 281-482-1714 Fax 281-482-9448

BATTERY REPLACEMENT:

• 1 Pc “AAA” or “UM4” battery

• Insert the battery as direction indicated.

Use fingernail to lift up battery cover and insert battery as to indicated direction.

Control Company is ISO 9001 Quality-

Certified by DNV and ISO 17025 accredited

as a Calibration Laboratory by A2LA.

CONTROL COMPANY

4455 Rex Road

Friendswood, Texas 77546 USA

E-mail sales@control3.com

www.control3.com