Control 4 C4-TW7C0-BL, C4-TW7C0-WH, C4-TSWMC5-EG-WH, C4-TSWMC7-EG-WH, C4-TSWMC5-EG-BL Installation Manual

™

7” In-Wall Touch Screen

NOTE: Video Intercom using 802.11b is not

recommended or supported for Video
Intercom. Control4 recommends Wireless-N
for Video Intercom. See “Wireless Network
Limitations” and “Power and Network
Installation Options.”

with Camera
Installation Guide

Introduction

The Control4® 7” In-Wall Touch Screen with Camera
oers complete system control in an elegant and
compact design. This Touch Screen is equipped
with a capacitive Touch Screen and four (4)
programmable shortcut buttons plus Audio and
Video Intercom (with a built-in camera) using SIP.

The available power options are AC power or Power­over-Ethernet (PoE); the network options are WiFi
or Ethernet connections. This Touch Screen supports
new construction or retrofit installations.

• AC. AC power is used to power the Touch
Screen when using an Ethernet or WiFi network
connection.

• PoE. PoE is used to power the Touch Screen
when using an Ethernet or WiFi network
connection.

The following table shows the available network
options with power.

• Option1:EthernetwithPoE. The Ethernet
network connection is provided through the PoE
Injector. No additional wiring is needed.

• Option2:EthernetwithAC. Connect the Touch
Screen to one of the RJ-45 LAN ports on the
gateway/router using the RJ-45 Ethernet cable.

• Option3:WiFiwithAC. The internal WiFi will
communicate with the LAN’s WAP. If the LAN has
a WAP set up, no additional wiring is needed.

Supported Models

• C4-TW7C0-BL - 7 Inch Wall Mount Capacitive
Touch Screen with Camera, Ethernet/WiFi, PoE/
Universal Voltage, Black

• C4-TW7C0-WH - 7 Inch Wall Mount Capacitive
Touch Screen with Camera, Ethernet/WiFi, PoE/
Universal Voltage, White

Associated SKUs:

• C4-TSWMC5-EG-WH – 5” In-Wall Touch Screen,
White (no camera)

• C4-TSWMC7-EG-WH – 7” In-Wall Touch Screen,
White (no camera)

• C4-TSWMC5-EG-BL – 5” In-Wall Touch Screen,
Black (no camera)

• C4-TSWMC7-EG-BL – 7” In-Wall Touch Screen,
Black (no camera)

Box Contents

Carefully unpack the contents of the box, and make
sure the following items are included. If any item is
missing or damaged, please contact your Control4
Reseller.

• Ethernet with PoE

• Ethernet with AC

• WiFi with AC

• 7” In-Wall Touch Screen with Camera

• Power box (used to power the Touch Screen)

• Two (2) screws to attach the power box

• Warranty card

1

™

7” In-Wall Touch Screen
with Camera
Installation Guide

Accessories

• PoE. Control4 Power over Ethernet Injector, sold

separately (AC-POE1-B).

• Back Box Options. There are four (4) back
box options available for this Touch Screen’s
installation. Metal and plastic back boxes
are available for new construction or retrofit
installations.

5”and7”In-WallTouchScreenBackBoxKits-
NewConstruction

- 5” and 7” In-Wall Touch Screens Wall Box,
New Construction, Plastic (C4-NWB57C-P)

- 5” and 7” In-Wall Touch Screens Wall Box,
New Construction, Metal (C4-NWB57C-M)

5”and7”In-WallTouchScreenBackBoxKit-
Retrot

- 5” and 7” In-Wall Touch Screens Wall Box,
Retrofit, Plastic (C4-RWB57C-P)

- 5” and 7” In-Wall Touch Screens Wall Box,
Retrofit, Metal (C4-RWB57C-M)

See the Control4 5” or 7” In-Wall Touch Screen

Wall Box Installation Guide - New Construction or
5” or 7” In-Wall Touch Screen Wall Box Installation
Guide - Retrofit for back box installation details.

Specifications

Screen 7” 16:9 wide VGA Color LCD Module

Resolution: 800 x 480
Camera: 640 x 480 VGA
Brightness: 350 nits

Wireless Built In IEEE802.11 b/g/n Wireless LAN

Integral Antenna (b/g/n supported)
Authentication: WEP, WPA, WPA2

Dimensions

(H x W x D)

Weight 1.15 lbs. (.52 kg)

Shipping Weight 1.8 lbs. (.81 kg)

Network WiFi (802.11 b/g/n) wireless access

4.88” x 7.2” x .60” (124 mm x 183 mm x
15 . 24 mm)

point (WAP) already configured
to communicate with a Control4
Controller (e.g., HC-800). Wireless-N is
recommended for Video Intercom.

Notes: (1) Intercom usage. 802.11b is not
recommended or supported for Video
Intercom. (2) Wireless-N is recommended
for Video Intercom. Even with Wireless-N,
broadcasting to several devices will
degrade Video Intercom response time and
images. Broadcasting to additional devices
will further degrade performance. See
“Wireless Network Limitations.”

Requirements

To install the 7” In-Wall Touch Screen with Camera,
Control4 requires the following:

• A Home Controller fully installed and configured

with a Control4® system.

• Control4 7” Touch Screen custom back box

installed (OS 2.2.1 or later). See “Accessories.”

• IfusingEthernetwithPoEpower:

- Ethernet network installed and available that
includes a gateway/router/switch

- Control4 PoE Injector (model #AC-POE1-B)
or another third-party PoE Injector or switch
(certified to UL/ANSI standards).

- Two (2) Ethernet CAT5 cables: (1) one that
runs from the Ethernet gateway/router/switch
to the PoE Injector/switch and (2) one that runs
from the PoE Injector/switch to the Ethernet
connection in the Touch Screen’s back box.

• IfusingEthernetwithACpower:

- Ethernet network installed and available that
includes a gateway/router/switch

- Access to in-wall AC power (a neutral
connection is required)

- One (1) Ethernet CAT5 cable that runs from
the Ethernet gateway/router/switch to the Touch
Screen

- A 14-gauge electrical wire long enough to pull
between the Touch Screen and the power source

• IfusingwirelesswithACpower:

- Wireless network (WiFi 802.11 b/g/n) installed
and available with a wireless access point (WAP)

- Access to in-wall AC power (a neutral

2

connection is required)

- A 14-gauge electrical wire long enough to pull
between the Touch Screen and the power source

Front and Rear Panel Descriptions

BackView

Figure 2. Back View - 7” In-Wall Touch Screen with
Camera and Power Box

FrontView

Figure 1. Front View - 7” In-Wall Touch Screen

3

4

1

2

1 Display. 7” viewing area, Touch Screen with 800 x

480 resolution.

2 Shortcut buttons (4). For custom programming;

to initiate an action or sequence of actions. Use
Composer Pro or Composer HE to configure
these buttons.

3 Green LED. Lets you know the camera is on.
4 Camera. For Video Intercom calls.

Dimensions

- Front dimensions. 7” Touch Screen (H x W x D):

4.88” x 7.2” x .60” (124 mm x 183 mm x

15.24 mm)

- Back box dimensions. 7” Touch Screen
(H x W x D): 2.7” x 4.1” x 2.4” (68 mm x 104 mm
x 61 mm)

- Power box dimensions. 7” Touch Screen (H x W
x D): 2.8” x 4.5” x 1.8” (71 mm x 114 mm x 46 mm)

Touch Screen Removal

Use the small hole located under the Touch Screen to
remove the Touch Screen from the wall (for details,
see Figure 10 in “Troubleshooting”).

2

1

1 Wire Connection. Hot (H) uses Black wire; Return

(R) uses White wire.

2 RJ-45 port for Ethernet Connection. Ethernet

port available for either a standard Ethernet
source that provides network communication
only OR a PoE source that provides power to the

device and network communication.

Touch Screen Placement

Place the Touch Screen in a convenient location at
eye level, typically near the entrance of the room,
approximately 57 to 61 inches (145 cm to 155 cm)
from the floor (see Figure 3).

NOTE: Consider the camera on the panel and

the height of the people in the home who will
use the camera for Video Intercom.

Figure 3. Touch Screen Placement

New Device

AC Power

(unless using PoE)

LED Indicator

The LED on the Touch Screen indicates the camera
status of the camera and booting information as
described in the next table.

3