Contrinex RFM30HF Users Manual

HF RFID SYSTEM

READ/WRITE MODULES (RWM)

RLS-1301-220

HOUSING READ/WRITE DISTANCE

M30 60 mm*

ü M30 Metal threaded housing

ü Sensing face of PBTP
ü Insensitive to dirt
ü ISO15693 compatible

ü USB RWM using Contri-

NET protocol

ü Cost optimized solution

* Please refer to table page 4

GENERAL DATA INTERFACE

Carrier frequency 13.56 MHz
Compatible standard ISO 15693 Data transfer rate 115 200 baud
Maximum transmission speed 26.5 kbit/s Number of bits 7 / stop bits / parity 8 / 1 / None
Read-write distance max.

ELECTRICAL DATA MECHANICAL DATA

Supply voltage range (Ub) 5 VDC (USB powered) Protection degree IP67
No-load supply current (field off) 100 mA Ambient temperature range TA** -25...+70 °C
Max. current consumption (no load) 200 mA Storage temperature range TS*** -25...+70 °C
Polling current 120 mA Sensing face material PBTP
Short-circuit protection

Voltage reversal protection
Max. output current Weight (incl. nuts) 165 g

** Read/write operations possible
*** Data retention and mechanical stability limit

60 mm with RTP-0501-020 RWM configuration

ü
ü

USB/VCP configuration

LED yellow on RWM live
LED yellow blinking Transponder detected
ContriNET protocol

Housing material Stainless steel

Connector type / Cable length USB A male / 2 m

ü

CONTRINEX AG Industrial Electronics

route du Pâqui 5 - P.O. Box - CH 1720 Corminboeuf - Switzerland - Tel: [phone] -
Fax: [phone] - Internet: www.contrinex.com - E-mail: [e-mail]

1

199

198

197

196

C7

C6

C5

C4

006

005

004

003

002

001

000

06

05

04

03

02

01

00

Block-Adressen

Adresses des blocs

Addresses of the blocks

Byte 0Byte 1

16 bit

HEXDEC

MOUNTING RECOMMENDATIONS

CLEARANCE

Read/write modules must not mutually influence each other. For this reason, a minimum distance of 2 x D between the devices must be observed.

sensing face

metal free zone

support

COMMUNICATION SETTINGS

USB/VCP characteristics Value for RLS-1301-220

Data transfer rate (default in bold) 115 200
Number of bits 8
Number of stop bits 1
Parity No

MEMORY STRUCTURE OF THE READ/WRITE MODULE

The Read/Write Module has a user memory of 3200 bits organized in 200 blocks of 16 bits. Each block is addressable separately by means of the
commands Write RWM and Read RWM.

2

CONTRINEX AG Industrial Electronics

route du Pâqui 5 - P.O. Box - CH 1720 Corminboeuf - Switzerland - Tel: [phone] -
Fax: [phone] - Internet: www.contrinex.com - E-mail: [e-mail]

TYPICAL TIMES

Time name Description

Starting times

Polling time

Execution time of the commands

Time between the powering of the RWM and the end of the first scanning of the
transponders present
Time for actualization of the list of the transponders present. This time depends on the
number of collisions.
The execution time is defined as the time between the end of the sending of the
command and the beginning of the answer

*Polling time for 16 transponders without collision

SLK-Strohmversorgung

Alimentation MLE

RWM power supply

Status

Durchsuchen nach laufenden Transponder

Balayage des transpondeurs présents

Scanning of the transponders present

Value

300 ms

70* ms

Command
dependent

Zeit / Temps / Time

T

Start

T

Poll

Zeit / Temps / Time

TYPICAL EXECUTION TIMES BY COMMAND TYPE

Command type Description

Commands related to RWM Typical execution time 1.5 ms

Commands related to Transponder
depending on number of blocks

Typical read duration: TR = T0 + N ·T
Typical write duration: TW = T0 + N ·T

Duration for decoding the command - T

R0

W0

Read duration for one block (32 bits) - T
Write duration for one block (32 bits) - T

0

R0

W0

Number of blocks concerned - N

Commands related to Transponder
not related to a number of blocks

Typical execution time
(e.g. Get System Info, Write AFI, Lock AFI, Write DSFID, Lock DSFID, and so on)

Signal

Befehl

Commande

Command

Antwort

Réponse

Answer

Value

12.0 ms

8.0 ms

12.0 ms

30 ms

CONTRINEX AG Industrial Electronics

Zeit / Temps / Time

Ausführungszeit

Temps d'exécution

Execution time

route du Pâqui 5 - P.O. Box - CH 1720 Corminboeuf - Switzerland - Tel: [phone] -
Fax: [phone] - Internet: www.contrinex.com - E-mail: [e-mail]

3

POSSIBLE COMBINATION AND TYPICAL DISTANCE - RLS-1301-220

y

R

0R0

+·

v

=o

f>0

f0

w

0W0

V

=o

f>0

f0

S

Transponder type

[mm] S0 [mm] D0 [mm] V

max

Ø 9 RTP-0090-020 14 3 22 110 91.7
Ø 16 RTP-0160-020 30
Ø 20 RTP-0201-020 25 10 30 150 125
Ø 26 RTP-0263-020 31 13 36 180 150
Ø 30 RTP-0301-020 45 21 48 240 200
Ø 50 RTP-0501-020 60 27 66 330 275
Ø 50 RTP-0502-022 50 22 56 280 233
Ø 50 RTP-0502-062 44.5 17.5 54 270 225
Ø 50 RTP-0502-082 42.5 17 51 255 212.5

*speed values for a distance between RWM and transponder set to S0 and a 32 bits Read or Write operation

D

2·( -)SS

0

Rmax

max0

T

TNT

+·

R

=

0R0

D

2· · 1-2·/SSS

C

=

T

max0max

TNT

b/si/i

ob/si/i

S

S0

0

Read/Write Module

Working area

Transponder

D

D

0

C

x

D

2·( -)SS

0

Wmax

max0

T

TNT

+·

W

=

0W0

D

2· · 1-2·/SSS

C

=

T

max0max

+·

TNT

b/si/i

ob/si/i

S

S0

0

S

0

S

max

[cm/s]* V

Rmax

Wmax

[cm/s]*

AVAILABLE TYPES

Part number Part reference Ø Mounting Connection / Cable length

720 100 109 RLS-1301-220 M30 Non-embeddable USB A male / 2 m

DISCLAIMERS

FCC information

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired operation.

Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the
equipment.

Note:This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his own expense.

IC information

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:

(1) This device may not cause interference, and

(2) this device must accept any interference, including interference that may cause undesired operation of the device.

Le présent appareil est conforme aux CNR d`Industrie Canada applicables aux appareils radio exempts de licence. L`exploitation est autorisée aux
deux conditions suivantes :

(1) L`appareil ne doit pas produire de brouillage, et

(2) l’utilisateur de l`appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d`en compromettre le fonctionne­ment.

Contrinex information

Operators of the products we supply are responsible for compliance with measures for the protection of persons. The use of our equipment in applica­tions where the safety of persons might be at risk is only authorized if the operator observes and implements separate, appropriate and necessary
measures for the protection of persons and machines. Terms of delivery and rights to change design reserved.

CONTRINEX AG Industrial Electronics

4

route du Pâqui 5 - P.O. Box - CH 1720 Corminboeuf - Switzerland - Tel: [phone] -
Fax: [phone] - Internet: www.contrinex.com - E-mail: [e-mail]

RLS-1301-220_171124_YAG