Continental Electric CP43139 User Manual
INSTRUCTIONMANUAL
HANDMIXER
CP43139
IMPORTANT SAFEGUARDS
Before using the electrical appliance, the following basic precautions
should always be followed including the following:
1. Read all instructions.
2. Before use check that the voltage of your wall outlet correspond to the
one on the rating plate which is on the bottom of the appliance.
3. Do not operate the appliance with a damaged cord or after malfunction
or has been damaged in any manner.
4. If the supply cord is damaged, it must be replaced by the manufacturer
or its service agent in order to avoid a electric shock.
5. Do not let cord hang over edge of table or counter or hot surface.
6. Do not immerse cord or the body of mixer into water as this would give
rise to electric shock.
7. Do not touch hot surface. Use handles or knobs only.
8. Close supervision is necessary when your appliance is being used near
children or inrm persons.
9. Do not place an appliance on or near a hot gas or on a heated oven.
10. Never eject beaters or dough hooks when the appliance is in
operation.
11. Ensure ngers are kept well away from moving beaters and dough
hooks.
12 Switch off the appliance before changing accessories or approaching
parts which move in use.
13. Do not operate the appliance for other than its intended use.
14. Do not use outdoors.
HOUSEHOLD USE ONLY
SPECIAL NOTES ON CORD PLUG
This appliance has a polarized plug(one blade is wider than the other).To
reduce the risk of electric shock, the plug can t into a polarized socket
only one way. If the plug does not t fully in the outlet, reverse the plug. If
it still does not t, contact a qualied electrician. Do not modify the plug in
any way.
SAVE THESE INSTRUCTIONS
KNOW YOUR HAND MIXER
USING YOUR MIXER
1. For the rst use, cleaning the dough hooks and beaters.
2. Assemble proper beaters or dough hooks into mixer.
Note: Beaters can be inserted in either socket, as the beaters are identical. For
dough hooks, the one with washer can only be inserted into the big socket and the
other one can only be inserted into small socket. The two dough hooks cannot be
inserted in reverse.
3.Ensure that the unit is at the 0 setting, then plug in the power source.
4.Turn the speed selector to your desired setting, there is 6 setting. The appliance
will start working and the speed will increase 15% if the Turbo Button depressed at
any time (the left is the same as the right, but can not depress at the same time).
Warning: Do not stick knife, metal spoons, fork and so on into bowl when
operating.
5.The max operation time per time shall not exceed 5 minutes and minimum 10
minutes rest time must be maintained between two consecutive cycles. When
kneading yeast dough, suggest the speed selector rst use a low speed and then
use high speed to achieve best results.
6.When mixing is completed, turn the speed selector to 0 setting, unplug the cord
from power outlet.
7. If necessary you can scrape the excess food particles from the beaters or dough
hooks by rubber or wooden spatula.
8.Hold the beaters/dough hooks with one hand and press the Ejection button rmly
down with the other hand, remove the beater/dough hooks.
Note: Remove the beaters/dough hooks only at the 0 setting.
Cleaning and Maintenance
1. Unplug the appliance and wait it completely cool down before cleaning.
2. Wipe over the outside surface of the mixer with a dampened cloth and polish
with a soft dry cloth.
3. Wipe any excess food particles from the power cord.
Loading...