IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should always be
followed to reduce the risk of re. Electric shook and injury to persons, including
the following:
1. please read these instructions carefully to get the best results from your
appliance.
2. Do not touch hot surfaces. Please use handles or knobs instead.
3. To protect against electrical shock, do not immerse cord, plugs ir unit in water
or other liquid.
4. Keep this blender away from children, close supervision is necessary when
blender is used by or near children.
5. Unplug from outlet when not in use and before cleaning. Allow to cool before
putting on or taking off parts.
6. Do not operate this blender with a damaged cord or plug or after it malfunctions
or has been damaged in any manner. Please return it to the nearest authorized
service facility for examination, repair or adjustment.
7. The use of not recommended attachments may cause injuries.
8. Do not use outdoors.
9. Do not let cord hang over edge of table or counter, or touch hot surfaces.
10. Do not place on or near a hot has or electric burner, or in a heated over.
11. Extreme caution must be used when moving an appliance containing hot oil or
other hot liquids.
12. Always attach plug to blender rst, then plug cord into the wall outlet. To
disconnect, turn switch to “off”, then remove plug from wall outlet.
13. Do not use this blender for other than its intended use.
SAVE THESE INSTRUCTIONS
For Household Use Only
FIRST USE
Before the rst use, please check if all the parts of the appliance are in good
condition. If not, please contact the supplier or manufacturer.
USING
1. Pour the required quantity of cold tap water into the jar. Do not exceed the
maximum level (refer to the markings on the inside of the jar).Do not use wine,
or any other ammable liquid.
2. Place the lid on the jar. Ensure that the lid is locked with the jar handle.
Thereby blocking the holes in the lid with the button provided.
3. Plug the blender in.
4. Push the speed knob to whatever mixing speed you need, or push the button
to pause and hold to keep mixing on. Caution: mixing at most every 60
seconds must stop and wait 60seconds before resetting.
5. Once mixing is complete, unplug the blender. Remove the jar carefully.
CLEANING
1. Remove the plug from the wall socket before cleaning.
2. To clean the jar and lid, use hot soapy water and soft cloth. Do not use abrasive
products. not dishwasher-safe.
3. To clean the base, remove any liquid still in the reservoir by tipping up the base
over a sink. Clean the inside with a damp cloth and allow to dry. This process
can be repeated for the outside of the base.
4. Clean the appliance with a damp cloth and never put it into water or ush it with
water.
CAUTION
1. The plug must be removed before cleaning the blender and it must be dried
before the blender is used again.
2. Do not use the blender if the lead is damaged.
3. If the power cable on the blender is damaged, it may only be replaced by
a repair center recognized by the manufacturer, since special tools are
required.
4. The blender must not be immersed in eater for cleaning purposes.
5. Do not use the blender for purposes other than that for which it is intended.
6. To ensure continued protection against risk of electric shock, connect to
properly grounded outlets only.