Continental A2C81541800 User Manual

The device under test is manufactured by the grantee (Continental Corporation) and sold as an
OEM product. Per 47 CFR 2.909, 2.927, 2.931, 2.1033, 15.15(b) etc…, the grantee must ensure
the end-user has all applicable / appropriate operating instructions. When end-user instructions
are required, as in the case of this product, the grantee must notify the OEM to notify the end­user.

Continental Corporation will supply this document to the reseller/distributor dictating what
must be included in the end user’s manual for the commercial product.

INFORMATION TO BE INCLUDED IN THE END USER'S MANUAL

The following information (in blue) must be included in the end product user’s manual to
ensure continued FCC and Industry Canada regulatory compliance. The ID numbers must
be included in the manual if the device label is not readily accessible to the end user. The
compliance paragraphs below must be included in the user's manual.

******************************************************************************

FCC ID: M3N-A2C81541800 IC: 7812A- A2C81541800

This device complies with Part 15 of the FCC Rules and with Industry Canada
license-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device
must accept any interference received, including interference that may cause
undesired operation.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.

Note: Changes or modifications not expressively approved by the party responsible
for compliance could void the user's authority to operate the equipment. The term
“IC:” before the radio certification number only signifies that Industry Canada
technical specifications were met.

******************************************************************************