Continental 11207900 User Manual

The device under test is manufactured by the grantee (Continental Corporation) and sold as an
OEM product. Per 47 CFR 2.909, 2.927, 2.931, 2.1033, 15.15(b) etc…, the grantee must ensure
the end-user has all applicable / appropriate operating instructions. When end-user instructions are
required, as in the case of this product, the grantee must notify the OEM to notify the enduser.

Continental Corporation will supply this document to the reseller/distributor dictating what must
be included in the end user’s manual for the commercial product.

INFORMATION TO BE INCLUDED IN THE END USER'S MANUAL

The following information (in blue) must be included in the end product user’s manual to
ensure continued FCC and Industry Canada regulatory compliance. The ID numbers must
be included in the manual if the device label is not readily accessible to the end user. The
compliance paragraphs below must be included in the user's manual.

******************************************************************************

M3N-11207900 7812A-11207900

This device complies with Part 15 of the FCC Rules and with Industry Canada license­exempt RSS standard(s). Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause undesired operation.

In order to comply with FCC/ISED RF Exposure requirements, this device must be
installed to provide at least 20 cm separation from the human body at all times.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1)
l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter
tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.

Afin de se conformer aux exigences d'exposition RF FCC / ISED, cet appareil doit être
installé pour fournir au moins 20 cm de séparation du corps humain en tout temps.

Note: Changes or modifications not expressively approved by the party responsible for
compliance could void the user's authority to operate the equipment. The term “IC:” before
the radio certification number only signifies that Industry Canada technical specifications
were met.

******************************************************************************