Contec SCP-8550-LLV User Manual

Ver.1.10

CompactPCI 6U
Single board computer

SCP-8550-LLV

* Specifications, color and design of the products are subject to

change without notice.

The supported CPU is as follows:
Intel(R) Pentium(R) M 1.6G - 2.0GHz(FSB400MHz),
Celeron(R) M 1.3G - 1.5GHz(FSB400MHz)

CompactPCI compliant 6U double-slot CPU board equipped
with 2 LANs and 2 display I/Fs (analog RGB, DVI-D)

Intel(R) 855GME+ICH4 chipset
Accommodates up to 2GB DDR SDRAM of main memory

(ECC function support)
Equipped with CF card slot (Type I/II), bootable from CF card.

One onboard frame for 2.5-inch HDD can be mounted.
Supports rear panel I/O (IDE, FDD, KEY/MOUSE, SERIAL,

PARALLEL, analog RGB, USB), optional rear panel I/O board
(SCP-RPIO-01)

This product, which is equipped with an 855GME chip set, is a
Compact PCI bus compliant PC/AT compatible 6U double slot
single board computer that supports Intel(R) Pentium(R) M
Processor 1.6G - 2.0GHz (FSB400MHz) CPU, Intel(R)
Celeron(R) M Processor 1.3G - 1.5GHz (FSB400MHz) CPU.
It features all-in-one-design with a variety of interfaces
including LAN x 2, DVI-D, EIDE, USB2.0 x 4, serial, parallel
and PS/2 Keyboard/Mouse. This product is also equipped with
a CF card slot (Type I/II), enabling boot-up from a CF card.
One 2.5inch HDD can be attached on board. Rear Panel I/O
correspondence, optional rear panel I/O board (SCP-RPIO-01)
is able to convert to the standard I/F connectors through the J4,
J5 connectors.

Specification Features

< 1 / 2 >

Item Specification

Supported CPU

Cache CPU build-in
Processor socket Socket 478

Memory (option)
Chipset Intel(R) 855GME+ICH4

BIOS Phoenix BIOS, PnP support
VGA
Keyboard/Mouse

connector

Serial port

Parallel port
On board expansion bus -

LAN Port

IDE I/F

SATA I/F ­FDD I/F 3.5 inches 2mode I/F CPCI J4 connector *2
CFslot TypeI/II x 1, IDE secondary port connection, Support booting
SDD socket -

USB port
RAID -

Audio -

Watchdog Ti mer

General-purpose I/O 3ch optical isolated inputs and outputs, 15Pin D-SUB(FEMALE) x1
Hardware Monitor

Intel(R)Pentium(R) M Processor 1.6G - 2.0GHz(FSB400MHz),
Intel(R)Celeron(R) M Processor 1.3G - 1.5GHz(FSB400MHz)
478 pin μFC-PGA

Max.2GB, 184 pin DIMM socket x 2, PC2700 DDR SDRAM,
Supported ECC

Intel 855GME built-in 15 pin HD-SUB connector x 1 and
CPCI J4 connector *1*2 DVI-D connector x 1 *4

PS/2 compatible mini-DIN x 2 and CPCI J5 connector *1*2
9 pin D-SUB(MALE) connector (RS-232C standard) x 2, CPCI J5

connector *1*2
Two 16550 UART ports, Baud rate: 115.2K - 50bps (programmable)
25 pin D-SUB(FEMALE) connector x 1, CPCI J5 connector *1*2
Support SPP/EPP/ECP mode

1000BASE-T/100BASE-TX/10BASE-T Intel 82541PI
100BASE-TX/10BASE-T Intel ICH4 integrated,
RJ-45 x 2, support Wake On LAN
EIDE port x 2, support Ultra DMA 33/66/100,
Primary : Connector for on-board 2.5 inches IDE (HDD load-able),
CPCI J5 connector *2*3
Secondary : CF slot connection and CPCI J4 connector *2*3
Access LED: Front panel *5

USB 2.0 standard 6ch
4ch: USB A TYPE connector(front panel), 2ch: CPCI J5 connector *2

1 - 255sec, 255 level
When time up : RESET, interrupt or external output is allowed at time
expiration.
Reset mode : Input to general purpose I/O of the external signal.

Monitoring of the temperature of CPU and board, power supply
voltage, and fan speed

SCP-8550-LLV 1

Ver.1.10

< 2 / 2 >

Item Specification

RTC/CMOS data backed up by Lithium battery
The following table lists the Lithium battery specifications (button-type)
Specification CR2450

RTC /CMOS

Power Management

Bus
specification/Size(mm)

DC Power
Requirements

Power supply
specifications(Max.)

Operating
temperature/
Operating humidity
Storage temperature -20 - 80°C
Floating dust particles Not to be excessive
Corrosive gases None
Weight 680g

Supported OS

*1 Each connectors of this board front panel cannot be used simultaneously with J4, J5

connector.

*2 When using the J4 and J5 connector signal, optional rear panel I/O board (SCP-RPIO-01)

and the CPCI back plain boards corresponding to rear panel I/O are required.

*3 The IDE drives (include on board HDD and CF card) can connect the primary port and the

secondary port each maximum two drives. Th e primary por t cannot be use d by U ltra D MA
66/100 mode while using on board HDD. The secondary port cannot be used by Ultra
DMA 66/100 mode while using CF card.

*4 The DVI-D connector can connect only the digital (Panel-Link) input type display. The

analog RGB input type display is not connectable.

*5 Access LED blinks at the time of access to on board HDD and CF card. It does not blink

at the time of access to the drive connect to IDE signal of J4, J5 connectors.
(SCP-RPIO-01 has the access LED of the device that connected to the IDE port of J4, J5
connectors.)

*6 unsupported.

Voltage 3V
Capacity 620mAh
Weight 6.3g

* The backup time of the CR2450 battery is over 7 years (In main
power is off, at 25oC).
* The clock is accurate to +/- 3 minutes/month at 25ºC.
Power management setup via BIOS
Modem Ring On*6/Wake On LAN
Supports PC98/PC99 ACPI Power management

CompactPCI (6U double slot) / 160.0(L) x 233.4(H)
+5VDC±5%,

+12VDC±5% (for the heat sink fan),
+5VSB(Stand by) ±5% (Only when using the ATX power supply)
+5VDC 9A,
+12VDC 0.25A(for the heat sink fan)
+5VSB(Stand by) 0.5A (Only when using the ATX power supply)
(When using the Pentium M 1.6 GHz)

0 - 50°C /20 - 90%RH (No condensation)

Windows XP Professional
Windows XP Home Edition
Windows 2000 Professional

Option List

CPU

PCPM-16F Pentium M 1.6GHz (with heat sink-fan)
PCPMC-13F Celeron M 1.3GHz (with heat sink-fan)

Memory (PC2700 DDR SDRAM DIMM, No parity)

PC-MDD256-184A 184-Pin DDR-Memory (PC2700, 256MB)
PC-MDD512-184A 184-Pin DDR-Memory (PC2700, 512MB)
PC-MDD512-184A 184-Pin DDR-Memory (PC2700, 512MB)

OTHER

SCP-RPIO-01 Rear Panel I/O Board

Packing List

CPU board [SCP-8550-LLV] …1
Product guide …1
IPC Precaution List …1
Driver disk utility *1 (CD-ROM) ...1
Jumper short pin (2mm) …2
Fixed bracket for on-board HDD …1
HDD fixed screws (M3 x 4) …4

*1 The CD-ROM contains the driver software and User’s Manual.

Connector & Jumper Location

Daughter Board

SER2
connector

Printer port
connector

S1: CF master/
slave selector,
genera l-purpose SW

S1

RAS
connector

On-board
HDD connector

43

44

1

2

CPU Board

FAN 1

Keyboard &
Mouse
Stack
Connector

SER1 connector

DVI connector

VGA connector

LAN1 connector
& USB 3/4 connector

LAN2 connector
& USB 1/2 connector

JP1: Clear CMOS

JP2: Clear CMOS

Back side

CF slot

Unused connector

1

CF slot

DIMM1/2:
184 pin DDR R AM
connector

FAN 2

External ATX
power control
connector

External
Battery
connector

CN7

J5

J4

J2

J1

SCP-8550-LLV 2