Consonance R150 Linear, Reference150 User Manual

1

R150 linear

USER GUIDE

Congratulations on your new CONSONANCE!
Our products are based on a simple philosophy:
The component shall reproduce the original musical sound, purely and naturally.
The products are easy to operate and are manufactured according to the best quality principles.
All CONSONANCE products are created with acoustical instruments in a concert situation as point of reference.

The music is reproduced exactly like the original and is limited only by the quality of the recording.

Our aim is to give you the best possible music experience!

CONTENTS

Sound Advice p.2
General use p.2
Remote Control p. 3
Use & Placement p. 3
Cleaning p. 4
Technical specifications p. 4
Note & Warning p. 4
Guarantee p. 4

2

SOUND ADVICE

The Consonance Reference150 Integrated Amplifier is easy to connect and operate and requires no prior
technical knowledge. However, to get the most out of the amplifier's superior sound and music quality, we have
provided a brief description of the connections and use of the amplifier in order to provide a total music
experience.

We recommend keeping this user guide for future reference.

GENERAL USE

The amplifier is switched on with the button ① in the left of the front panel. A flashing " -- -- --" blue light in the
display ② indicates that power is switched on. By pushing the same button one more time the power is switched
off.

When power is switched on, the blue indicator located behind the left side of display will light and keep flashing
slightly. After about 30 seconds, the blue indicator will stop flashing and indicate normal tube filament operation.

Note: It takes about 1 minute for the 6H30 tube to reach its normal operating point, and only slight sonic
improvement will be noticed after 5 minutes.

the left knob ③ is the channel selector with selections:INPUT1(“ IN1”), INPUT2(“ IN2”), INPUT3(“ IN3”),
BALANCED INPUT(“BAL”) , and the right knob ④ is the volume control.

Note: all the function of input selecting and volume control could be displayed on the screen, which will
go automatically dim 20 seconds later. When the mute function is switched on, the present volume level
will keep flashing on the screen to indicates mute mode is on.

Avoid connecting input cables or selecting inputs with the source selector switch if the volume setting of the
amplifier is not fully turned down and the speakers are connected. A transient signal might then arise, which can
damage the speakers. The amplifier will not be harmed, but to avoid overloading the speakers, the volume should
be turned fully down or the mute function should be switched on when connecting and disconnecting cables.

Note: The volume will be turned fully down automatically when the amplifier is switched off and re­switched on for the same reason.

After the amplifier is switched on, there is a delay of about 30 seconds for the music signal to reach the speaker
outputs. The amplifier is protected against short-circuiting of the speaker terminals , but we still recommend
turning off the amplifier when connecting and disconnecting signal and speaker cables.