CONSEW CSM1001 Instruction Manual

Since 1898

CON-SERV

Model CSM1001

ADJUST SPEED SETTING

1. PRESS THE R BUTTON, YOU WILL SEE UO

2. PRESS THE M BUTTON. IT WILL SHOW YOU THE SPEED THE MOTOR IS CURRENTLY ON

3. CONTINUE TO PRESS THE M BUTTON UNTIL YOU REACH THE DESIRED SPEED EXAMPLE: 5= 500, 12= 1200

4. PRESS THE R BUTTON TO SAVE THE SPEED THAT YOU HAVE CHOSEN

SET NEEDLE POSITION

1. PRESS THE R BUTTON UNTIL YOU SEE U1

2. THEN PRESS THE M BUTTON, IT SHOULD SHOW YOU #0

3. PRESS THE M BUTTON TO CHANGE TO #1, PRESS THE R BUTTON TO SAVE 0= NEEDLE POSITION DOWN 1= NEEDLE POSITION UP, PRESS R TO SAVE

Servo Motor

CSM1001 MOTOR MANUAL

CHANGE DIRECTIONS

1. PRESS R BUTTON UNTIL IT SHOWS U2

2. PRESS THE M BUTTON UNTIL YOU SEE #0 CONTINUE TO PRESS THE M BUTTON UNTIL YOU SEE #1 #0= CLOCKWISE #1= REVERSED

3. PRESS R TO SAVE

LOCATION PARAMETER SETTING “NEEDLE POSITIONING SPEED”

1. PRESS THE R BUTTON UNTIL YOU SEE U3

2. PRESS THE M BUTTON UNTIL YOU SEE THE NUMBER DISPLAYED

3. PRESS THE M BUTTON UNTIL YOU REACH THE DESIRED NUMBER THE LOWER THE NUMBER, THE SLOWER THE SPEED THE HIGHER THE NUMBER, THE FASTER THE SPEED

4. PRESS R TO SAVE

SLOW START SETTING

1. PRESS THE R BUTTON UNTIL YOU SEE U4

2. PRESS THE M BUTTON, IT WILL DISPLAY #0

3. CONTINUE TO PRESS THE M BUTTON TO THE DESIRED NUMBER

4. PRESS R TO SAVE 0=9 9 IS THE SLOWEST START

Specifications subject to change without notice.